BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
NEMIX RAM
A 16 GB dual-channel DDR5 kit running at 4800 MHz with CL40 latency and 1.1 V operation
This NEMIX RAM kit supplies 16 GB across two 8 GB DDR5 modules rated at 4800 MHz with CAS latency 40. The unbuffered non-ECC design suits desktop platforms that accept standard UDIMMs and do not require registered memory. Builders adding capacity to a compatible DDR5 system will find the dual-channel pair straightforward to install.
Each module runs at 1.1 V and uses the 288-pin DDR5 form factor, so the kit fits motherboards wired for this generation without extra power adapters. The 1Rx8 organisation leaves room for additional modules on boards with four slots, and the low voltage helps keep thermal headroom available for other components.
The kit replaces slower DDR5 memory or smaller capacity pairs when the platform supports 4800 MHz operation and non-ECC UDIMMs. The jump is worthwhile when the motherboard and processor can run at the rated speed, delivering higher bandwidth than lower-frequency DDR5 alternatives. Systems locked to registered or ECC-only memory cannot use this kit.
| Brand | NEMIX RAM |
|---|---|
| Model | Part#: MD38400-818K2-SM-SYS-111AD-HN2-01-G2 |
| Part Number | Part#: MD38400-818K2-SM-SYS-111AD-HN2-01-G2 |
| Capacity | 16GB (2 x 8GB) |
| Speed | DDR5 4800 (PC5 38400) |
| CAS Latency | 40 |
| Voltage | 1.1V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
The CL40 timing is the JEDEC standard for DDR5 4800 and sets the base response speed; tighter timings would require modules rated for lower latency at this frequency.
At 1.1 V the kit runs at the standard DDR5 voltage, so power consumption and thermals stay within normal limits for continuous use without extra cooling.
Yes, the board needs a 288-pin DDR5 DIMM socket and must accept non-ECC unbuffered memory; the 1Rx8 organisation also requires compatible memory-controller support.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?