BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.
NEMIX RAM
64 GB kit of four 16 GB DDR4 ECC UDIMMs running at 2400 MHz with CL17 latency and 1.2 V operation
This 64GB kit contains four 16GB DDR4 2400MHz modules built with ECC error correction and an unbuffered design. It targets administrators upgrading compatible servers or workstations that require registered-free memory at PC4-19200 speed. The modules operate at a standard 1.2V and carry a CAS latency of 17 for stable operation.
Each stick uses a 2Rx8 organisation assembled from major OEM Samsung, Micron or Hynix components on a 288-pin UDIMM PCB. The unbuffered layout means the modules plug directly into standard DDR4 slots without a register chip, simplifying installation in platforms that support ECC unbuffered memory. Gold-edge contacts resist oxidation during long service cycles.
Before ordering, verify that your motherboard or system accepts DDR4 2400MHz ECC UDIMM modules and can populate four slots with a 2Rx8 configuration. Confirm the platform does not require registered or load-reduced DIMMs, which are electrically incompatible. Ensure the BIOS can initialise the full 64GB capacity at the rated speed and latency.
| Brand | NEMIX RAM |
|---|---|
| Model | Part#: ME19200-628K4-SM-SYS-5019S-L |
| Part Number | Part#: ME19200-628K4-SM-SYS-5019S-L |
| Capacity | 64GB (4 x 16GB) |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | 17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major OEM Samsung, Micron, Hynix |
Each module is rated for 2400 MT/s and PC4-19200, the industry designation for that speed grade; real-world throughput depends on the platform's memory controller.
The kit uses standard 288-pin DDR4 UDIMM form factor, so it fits any server or workstation board that accepts unbuffered ECC DDR4 DIMMs.
Populate the slots in the order shown in the motherboard manual — usually one per channel first — and press each DIMM down until both side clips click; the common mistake is stopping before the clips latch fully.
Aj v tomto oddelení
Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.
Mena, v ktorej platíte, a mena, v ktorej sa zobrazujú ceny.
Odoslané z vašej peňaženky na pokladni
Len na zobrazenie — katalóg je uvedený v dolároch
Žiadna mena nezodpovedá.
Vyberte jazyk, v ktorom s vami bude web komunikovať.
Žiadny jazyk nezodpovedá.
Ste tu prvýkrát?
Účet už máte?
Automatický reset hesla neexistuje: tento obchod neposiela žiadne e-maily, takže neexistuje jednorazový odkaz, o ktorý by ste mohli požiadať. Nechajte adresu na účte — niekto sa jej ujme ručne.
Žiadosť zaznamenaná
Do vašej schránky nič nepríde — tento obchod neposiela vôbec žiadne e-maily. Niekto sa o to postará ručne.
Spomenuli ste si?