NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
A-Tech
8GB DDR4 desktop DIMM running at 2133MHz with 1.20V operation for AMD and Intel systems
This 8 GB DDR4 module runs at 2133 MHz (PC4-17000) and uses the standard 1.20 V voltage. It is built as a single 288-pin unbuffered DIMM with a 2Rx8 organisation. The memory is designed as a direct replacement for Micron MTA16ATF1G64AZ-2G1 series modules and is tested for compatibility with both AMD and Intel desktop platforms.
The tested frequency is 2133 MHz at 1.20 V with no ECC and no registered buffer. These three figures decide whether the module will post and run stably in a given motherboard. Buyers who need ECC error correction or a different data rate cannot use this part.
At the standard DDR4 voltage of 1.20 V the module draws minimal power and produces little heat during normal desktop workloads. No active cooling is required and acoustic output is negligible. Systems with restricted airflow will not see a thermal penalty from adding this memory.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR4 2133 (PC4 17000) |
| Tested Frequency | 2133 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
The module is tested at 2133MHz and will operate at that speed if the motherboard and CPU memory controller support DDR4 2133; otherwise it will run at the highest speed both components can agree on.
PC4-17000 represents a peak transfer rate of 17000 MB/s for DDR4 2133; real-world throughput will be slightly lower due to protocol overhead and system latency.
It uses a 288-pin DIMM form factor designed for desktop DDR4 sockets; the module is unbuffered and non-ECC, matching standard consumer motherboard slots.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?