OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
8GB DDR4 desktop DIMM running at 2133MHz with 1.20V operation for AMD and Intel systems
This 8 GB DDR4 module runs at 2133 MHz (PC4-17000) and uses the standard 1.20 V voltage. It is built as a single 288-pin unbuffered DIMM with a 2Rx8 organisation. The memory is designed as a direct replacement for Micron MTA16ATF1G64AZ-2G1 series modules and is tested for compatibility with both AMD and Intel desktop platforms.
The tested frequency is 2133 MHz at 1.20 V with no ECC and no registered buffer. These three figures decide whether the module will post and run stably in a given motherboard. Buyers who need ECC error correction or a different data rate cannot use this part.
At the standard DDR4 voltage of 1.20 V the module draws minimal power and produces little heat during normal desktop workloads. No active cooling is required and acoustic output is negligible. Systems with restricted airflow will not see a thermal penalty from adding this memory.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR4 2133 (PC4 17000) |
| Tested Frequency | 2133 |
| Voltage | 1.20V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
The module is tested at 2133MHz and will operate at that speed if the motherboard and CPU memory controller support DDR4 2133; otherwise it will run at the highest speed both components can agree on.
PC4-17000 represents a peak transfer rate of 17000 MB/s for DDR4 2133; real-world throughput will be slightly lower due to protocol overhead and system latency.
It uses a 288-pin DIMM form factor designed for desktop DDR4 sockets; the module is unbuffered and non-ECC, matching standard consumer motherboard slots.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟