A-Tech
A-Tech 16GB DDR3L 1333 ECC RDIMM 2Rx4 Server RAM
16GB DDR3L 1333 ECC registered server DIMM with 2Rx4 layout and 1.35V low voltage
- Capacity16GB
- SpeedDDR3L 1333 (PC3L 10600)
- CAS LatencyCL9
- Voltage1.35V
- ECCYes
- Buffered/RegisteredRegistered
- ECC protection safeguards data integrity with registered DDR3L 1333 operation
- 16 GB capacity expands server headroom for heavier workloads
- Low 1.35 V DDR3L voltage reduces power draw in dense configurations
- 2Rx4 dual-rank organisation improves memory controller efficiency
- 240-pin DDR3 DIMM form factor fits standard registered server slots
16GB DDR3L ECC RDIMM for Servers
This 16GB DDR3L 1333MHz registered DIMM delivers error-correcting memory for server and workstation platforms. It operates at 1.35V low voltage with CL9 latency and uses a 2Rx4 organisation on a 240-pin interface. The module replaces specific Hynix part numbers and undergoes quality assurance testing for dependable operation.
Suited for ECC Registered Slots Only
This memory fits systems that require DDR3L ECC registered DIMMs and accept 1.35V modules at 1333MHz. It will not work in platforms that need unbuffered UDIMMs, non-ECC memory, standard 1.5V DDR3, or different DDR generations. Builders without registered ECC support should look at other memory types.
Single Module Frees Remaining DIMM Slots
The 1x16GB configuration occupies one registered DIMM slot, leaving other slots available for further capacity expansion within the platform limits. The low-voltage DDR3L design reduces power draw per module compared to standard DDR3. Verify your system's qualified vendor list and maximum supported capacity before installation.
จุดเด่น
- ECC protection safeguards data integrity with registered DDR3L 1333 operation
- 16 GB capacity expands server headroom for heavier workloads
- Low 1.35 V DDR3L voltage reduces power draw in dense configurations
- 2Rx4 dual-rank organisation improves memory controller efficiency
- 240-pin DDR3 DIMM form factor fits standard registered server slots
ข้อมูลจำเพาะ
| Brand | A-Tech |
|---|---|
| Capacity | 16GB |
| Speed | DDR3L 1333 (PC3L 10600) |
| CAS Latency | CL9 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
คำถามเกี่ยวกับสินค้านี้
Does my server need DDR3L 1333 registered ECC slots to use this 16GB module?
Yes, the module is a DDR3L 1333 (PC3L-10600) ECC RDIMM that requires a 240-pin registered DDR3L slot supporting 1.35V operation.
Can I mix this 2Rx4 registered stick with older unbuffered DDR3 DIMMs in the same system?
No, registered and unbuffered DIMMs cannot be mixed; the motherboard must support registered memory and all populated slots should use registered modules.
How can I confirm the 16GB stick is running at 1333 MT/s with ECC active after installation?
Check the BIOS memory information or run a tool such as dmidecode to verify speed shows 1333 MT/s, voltage reads 1.35V, and ECC status reports enabled.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



