KHACHIMO
KHACHIMO AT Power Supply 300W SPI-300G SD-250AT
AT power supply delivering 300 watts for P8 and P9 systems
- TypeATX
- 300 W output powers legacy AT systems
- 250 W continuous rating supports stable operation
- ATX form factor fits standard chassis
- Tested working for reliable performance
Compatible AT power supply for legacy systems
This 300 W AT-type unit carries the SPI-300G and SD-250AT designations and is tested working before dispatch. It is intended for older PCs that still use the P8 and P9 motherboard connectors rather than modern ATX plugs.
P8 and P9 connectors replace standard ATX headers
The bundled wiring harness provides the two six-pin blocks required by classic AT mainboards, removing the need for adapters. Builders working on vintage hardware can install the unit directly, while anyone with a current ATX board will find the connector layout unsuitable.
จุดเด่น
- 300 W output powers legacy AT systems
- 250 W continuous rating supports stable operation
- ATX form factor fits standard chassis
- Tested working for reliable performance
ข้อมูลจำเพาะ
| Type | ATX |
|---|
คำถามเกี่ยวกับสินค้านี้
Will the internal fan need periodic cleaning or eventual replacement on the SPI-300G?
The 300 W AT supply uses a standard cooling fan; dust buildup should be cleared every few months and the fan itself typically lasts several years before bearing wear requires a swap.
Which limit appears first when the SD-250AT runs continuously at full load?
The 250 W continuous rating is reached before the 300 W peak, so sustained output is capped at the lower figure and the protection circuit will engage if that level is exceeded.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที



