Zyvpee
Zyvpee 4710NL-04W-B39 120mm 3-pin case fan
A 120 mm ball-bearing case fan with a 3-pin connector for CPU cooler compatibility
- TypeCPU Cooler Fan
- CompatibilityCPU Cooler
- Bearing TypeBall
- Power Connector3 Pin
- ColorBlack
- LEDNon-LED
- Ball bearing for longer service life
- 12 V 0.32 A draws minimal power
- 120 mm × 25 mm fits standard mounts
- Three-pin connector enables speed reporting
- Non-LED black frame keeps build subtle
Zyvpee 120mm Ball-Bearing Case Fan
The Zyvpee 4710NL-04W-B39 is a 120 by 25 millimetre DC fan built for CPU cooler and chassis airflow duties. It runs on 12 volt power and draws 0.32 amp through a standard three-pin connector. The black frame carries no lighting, so it suits builds that prefer a neutral look.
Replacing Sleeved or Worn 3-Pin Fans
Swap this unit in when an existing 120 millimetre fan develops bearing noise or fails to spin at full speed. The ball-bearing design lasts longer than sleeve alternatives, making the change worthwhile for systems that run continuously or sit in warm enclosures. It fits any mount spaced for 120 millimetre holes.
Steady Airflow Under Continuous Load
Ball bearings maintain consistent rotation when the fan runs for extended periods at 12 volts. The three-pin header reports speed to the motherboard so the board can adjust voltage in response to temperature. Without PWM control the fan settles at a fixed voltage level rather than ramping sharply.
จุดเด่น
- Ball bearing for longer service life
- 12 V 0.32 A draws minimal power
- 120 mm × 25 mm fits standard mounts
- Three-pin connector enables speed reporting
- Non-LED black frame keeps build subtle
ข้อมูลจำเพาะ
| Brand | Zyvpee |
|---|---|
| Series | 4710NL-04W-B39 |
| Model | 4710NL-04W-B39 |
| Type | CPU Cooler Fan |
| Compatibility | CPU Cooler |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| Color | Black |
| LED | Non-LED |
| Features | Power Case Fan |
| Dimensions | 120*25MM |
คำถามเกี่ยวกับสินค้านี้
What case clearance does the 120*25MM frame need?
The 120*25MM square frame fits any standard 120 mm mounting hole pattern with at least 25 mm depth behind the panel.
How do I connect the 3-pin plug so the motherboard reads speed correctly?
Align the keyed 3-pin connector with the motherboard CPU_FAN or SYS_FAN header; the third wire carries the tachometer signal for RPM monitoring.
When should the ball-bearing assembly be replaced?
Replace the fan if bearing noise appears or RPM drops below spec; ball bearings typically run for years but are not user-serviceable.
อื่น ๆ ในหมวดนี้
ลูกค้ามักเปรียบเทียบสินค้าเหล่านี้
หมวดเดียวกัน การชำระเงินแบบเดียวกัน — แปดสกุลเงินคริปโตและอัตราแลกเปลี่ยนที่ล็อกไว้ 30 นาที
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



