OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
8GB DDR3L 1333MHz ECC registered DIMM, 2Rx4 at 1.35V for server upgrades
This 8GB DDR3L module is built for servers and workstations that require registered ECC memory. It replaces Hynix HMT41GV7BMR4A-H9 and HMT41GV7CMR4A-H9 parts in compatible systems. The module is not suited for desktop boards that only accept unbuffered non-ECC DIMMs.
The stick uses a 240-pin DIMM form factor with a 2Rx4 organisation and major-brand chips. Registered signalling and on-board ECC reduce electrical load on the memory controller and correct single-bit errors, which is essential for 24/7 server workloads. Buyers needing unbuffered or non-ECC memory should look elsewhere.
Rated at 1.35V, the DDR3L module draws less power and generates less heat than standard 1.5V DDR3 at the same 1333MHz CL9 speed. Lower thermals help keep chassis fans quiet in dense rack environments. Systems that cannot run DDR3L at 1.35V will not support this module.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for Hynix |
| Model | HMT41GV7BMR4A-H9, HMT41GV7CMR4A-H9 |
| Capacity | 8GB |
| Speed | DDR3L 1333 (PC3L 10600) |
| CAS Latency | CL9 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | HMT41GV7BMR4A-H9, HMT41GV7CMR4A-H9 |
Yes, the module runs at DDR3L 1333 (PC3L-10600) with CL9 latency, so throughput is limited to that rated speed.
It fits a standard DDR3 240-pin DIMM socket; the low-voltage DDR3L keying matches DDR3 slots that support 1.35V operation.
Ensure the server supports registered ECC memory and enable ECC in the BIOS after seating the module firmly until the retention clips lock.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟