A-Tech 8GB DDR4 2933 MHz ECC SODIMM 1Rx8 CL21 1.2V
- 8GB
- 260-Pin DDR4 SO-DIMM
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
8 GB DDR4 ECC SODIMM at 2666 MHz with CL19 latency and 1.2 V operation for compatible laptops and microservers
Capacity 8GB
Speed DDR4 2666 (PC4 21300)
This A-Tech module provides 8GB of DDR4 memory at 2666 MHz with ECC error correction. It uses the 260-pin SO-DIMM form factor and runs at the standard 1.2V JEDEC voltage. The single-rank 1Rx8 design targets systems that require unbuffered ECC memory for data integrity.
Buyers whose platforms do not support ECC unbuffered SODIMMs cannot use this module. It is not for systems limited to non-ECC memory or those requiring registered DIMMs. The fixed CL19 latency and 2666 MHz speed also exclude builds that demand higher frequencies or lower timings.
The single module fills one slot, leaving room for expansion if the board has additional sockets. Capacity runs out when workloads exceed 8GB, such as large virtualisation sets or heavy database caches. ECC protection covers single-bit errors but does not increase the physical memory ceiling.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR4 ECC SODIMM |
| Model | A-Tech 8GB 1Rx8 PC4-21300 ECC SODIMM |
| Part Number | NE-SS-0572 |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | ECC SODIMM |
| Recommend Use | AMD & Intel Compatible |
| Option | ECC SODIMM |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Yes, the module is a single 8 GB stick with a 260-pin DDR4 SO-DIMM form factor, so it installs in one slot and provides the full capacity without needing a matched pair.
Mixing ECC and non-ECC memory typically disables error correction on both modules, and the system will run at the lower of the two speeds with the looser timing.
Enter the BIOS or UEFI and look for an ECC status line showing enabled, or run a system-information tool that reports ECC capability as active for the installed memory.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟