EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
ASRock
8GB GDDR6 card with 2304 stream processors, up to 1750 MHz boost, 256-bit bus, 3 DisplayPort 1.4 and HDMI 2.0b for 8K 60 Hz, dual 8-pin power, 281 x 137 x 42 mm
The ASRock Challenger D 8G OC uses the AMD Radeon RX 5700 core built on a second-generation 7nm process with RDNA architecture. It provides 8GB of 256-bit GDDR6 memory running at 14 Gbps and 2304 stream processors. PCI Express 4.0 support and DirectX 12 compatibility suit modern 1440p gaming builds. Outputs include three DisplayPort 1.4 and one HDMI 2.0b for up to four displays.
Moving to this card from a 1080p-class GPU adds the memory bandwidth and compute needed for higher resolutions and refresh rates. The jump is worth it when your monitor exceeds 1080p or when titles demand more than 4GB VRAM. Base frequency sits at 1515 MHz with gaming frequency up to 1675 MHz and dynamic speedup up to 1750 MHz. A 600W power supply and two 8-pin connectors are required.
At 281 x 137 x 42mm the card fits most mid-tower cases and uses a conventional dual-slot bracket. Installation follows the usual PCIe x16 seat and two 8-pin power cables; a quick installation guide is included. Common issues are forgetting the second power connector or using a PSU below the 600W recommendation. Ensure the case has clearance for the 281mm length before ordering.
| Memory Size | 8GB |
|---|---|
| Memory Type | GDDR6 |
The card measures 281 mm long, 137 mm wide and 42 mm thick. Check your chassis clearance against those dimensions and ensure two 8-pin power cables can reach the connectors.
Align the gold edge connector with the motherboard PCIe 4.0 slot, press down until the retention clip clicks, then firmly connect both 8-pin power cables from the PSU; forgetting either plug will prevent the card from starting.
Re-paste if temperatures rise noticeably after a few years or when you disassemble the cooler for cleaning; use a pea-sized dot of non-conductive paste on the 2304-stream-processor die.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟