نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.

قائمة الرصد تسجيل الدخول
Six bare green DDR5 RDIMM sticks in a row

NEMIX RAM

NEMIX RAM 768GB 6x128GB DDR5-6400 ECC RDIMM CL52 1.1V 2Rx4 Supermicro H14DST-F memory upgrade

SKU CH-VYF0-YHVP7

Six 128 GB DDR5-6400 ECC registered DIMMs totalling 768 GB at 1.1 V CL52, validated for the Supermicro H14DST-F motherboard

  • Capacity768GB (6 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes
  • 768 GB total capacity from six 128 GB modules for maximum memory density
  • DDR5-6400 speed with CL52 latency delivers rated bandwidth for server workloads
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operating voltage matches the motherboard's electrical specification exactly
  • Validated for the Supermicro H14DST-F with 288-pin RDIMM form factor

Exact-match kit for Supermicro H14DST-F

This 768 GB kit contains six 128 GB DDR5-6400 RDIMMs built to the 2Rx4 registered ECC specification the H14DST-F memory controller expects. It runs at 1.1 V with CL52 latency so the server recognises full capacity and rated speed immediately.

Suited for fully populating the H14DST-F

Administrators expanding a Supermicro H14DST-F to its maximum supported memory will use this kit. Builders who need unbuffered UDIMMs, SODIMM form factor, lower capacities or non-ECC modules should look elsewhere because this product is registered ECC RDIMM only.

Straightforward installation with manual checks

The 288-pin RDIMMs seat in the standard DDR5 slots, but the board's population order and per-channel limits must be followed exactly. Skipping the manual's DIMM sequence is the most common cause of modules not being detected or running at reduced speed.

أبرز المميزات

  • 768 GB total capacity from six 128 GB modules for maximum memory density
  • DDR5-6400 speed with CL52 latency delivers rated bandwidth for server workloads
  • Registered ECC architecture corrects single-bit errors and offloads the memory controller
  • 1 V operating voltage matches the motherboard's electrical specification exactly
  • Validated for the Supermicro H14DST-F with 288-pin RDIMM form factor

المواصفات

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-724K6
Capacity768GB (6 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content768GB 6X128GB DDR5 6400MHz PC5-51200 2Rx4 1.1V 288-PIN ECC RDIMM KIT

أسئلة حول هذا المنتج

What motherboard must I already own for this 6x128GB DDR5-6400 ECC RDIMM kit to work?

This kit is verified for the Supermicro H14DST-F motherboard; it requires that board's 288-pin RDIMM slots and registered-DIMM memory controller.

Will these 2Rx4 registered ECC modules run alongside any existing RDIMMs I keep in the H14DST-F?

The H14DST-F's memory population rules determine mixed-rank support; install this 768GB kit in the approved slot order from the board manual and do not mix with UDIMMs or SODIMMs.

After installation, how do I confirm the kit is running at its rated DDR5-6400 CL52 1.1V settings?

Enter the system BIOS or UEFI and check that total capacity reads 768GB, data rate shows 6400 MT/s, CAS latency reads 52, voltage reads 1.1V, and ECC status is enabled.

أيضًا في هذا القسم

عملاء قارنوا هذه المنتجات

نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.