OEM Industries
OEM Industries AD07012HX207300 70mm 12V .23A 3-pin hydraulic fan
A 70 mm hydraulic-bearing case fan with a 3-pin 12 V .23 A connector for compact cooling
- ColorBlack
- TypeFan only
- Fan Size70mm
- Bearing TypeHydraulic
- Power Connector3 Pin
- LEDNo
- 70 mm frame fits tight chassis spaces
- Hydraulic bearing reduces friction for quieter operation
- 12 V 0.23 A draw keeps power use low
- Three-pin connector enables simple motherboard control
- 20 mm thickness suits slim projectors and cases
Compact 70 mm hydraulic fan for tight builds
This OEM Industries 70 mm fan uses a hydraulic bearing and runs on 12 V at 0.23 A through a standard 3-pin connector. It is designed for small-form-factor cases, projector coolers or any slot that only fits a 70 x 20 mm frame. The black finish keeps the look neutral inside the chassis.
Direct swap for worn 70 mm sleeve-bearing units
Replace an ageing 70 mm fan that has become noisy or lost airflow with this hydraulic-bearing model. The upgrade is worth it when the original fan uses a sleeve bearing that has dried out, or when the 3-pin header on the board is the only available connection. No larger fan will fit the same mounting holes.
Verify 70 mm mounting spacing
Measure the screw-hole pattern to confirm it matches the 70 mm square layout. Ensure the motherboard or fan controller provides a 3-pin header; a 4-pin PWM header will run the fan at full speed without speed control. Check that 12 V and 0.23 A are within the header’s current limit.
أبرز المميزات
- 70 mm frame fits tight chassis spaces
- Hydraulic bearing reduces friction for quieter operation
- 12 V 0.23 A draw keeps power use low
- Three-pin connector enables simple motherboard control
- 20 mm thickness suits slim projectors and cases
المواصفات
| Model | AD07012HX207300 |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 70mm |
| Bearing Type | Hydraulic |
| Power Connector | 3 Pin |
| LED | No |
أسئلة حول هذا المنتج
Will this 70mm fan fit a standard 70mm mounting pattern?
Yes, the 70mm frame matches the common 70mm hole spacing used on many cases and coolers.
How do I connect the 3-pin connector to a 4-pin motherboard header?
Align the keyed 3-pin plug with the 4-pin header's guide; the fourth pin stays empty and speed is controlled by voltage.
Does the hydraulic bearing need lubrication later?
No, the sealed hydraulic bearing is maintenance-free for the fan's service life.
أيضًا في هذا القسم
عملاء قارنوا هذه المنتجات
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
