OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
Replace Power
A 420W ATX power supply with an 80mm fan, switchable 110V and 220V input, and connectors including 20+4 ATX, ATX12V, SATA, peripheral and floppy
This 420W ATX power supply replaces faulty or ageing units in HP desktops and other compatible systems. It delivers the rated wattage through a standard ATX form factor with a single 80mm fan for cooling. The grey chassis fits directly into the same mounting points as the original equipment.
The unit serves as a direct swap for HP part numbers 376649-001 405479-001 405872-001 410507-002 and matches the original 420W rating. The jump is worth it when the existing supply has failed, shows voltage instability or cannot sustain load under normal operation. Input voltage is switchable between 110V and 220V for regional compatibility.
The supply provides one SATA connector, a 20+4 pin ATX connector, a 12V ATX connector, two large peripheral connectors, two short peripheral connectors and one floppy connector. Cable lengths of 14-inch and 15-inch reach typical drive bays and motherboard headers. Builders needing additional SATA devices or multiple 12V CPU connectors should verify requirements before purchase.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-8 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
The unit uses a single 80 mm fan; allow enough depth behind the rear panel for the fan housing and cable bend radius so airflow is not restricted.
The supplied 14-inch ATX lead supports both 20-pin and 24-pin layouts; plug the full 24-pin block into the board and leave the extra four pins unattached if the socket is 20-pin.
Clean the 80 mm fan intake with compressed air every six to twelve months; replace the fan if bearing noise appears or airflow drops noticeably.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟