Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Aqua blue duplex multimode fibre patch cord with LC and ST connectors, 30m length

Enfain

Enfain OM3 LC-ST Duplex Multimode Fibre Optic Cable 30m

SKU CH-X1T0-9P43E

A 30-metre OM3 duplex cable with LC and ST connectors carries 10-gigabit data at 850 nm through a 3.0 mm PVC jacket

Length 30m

  • Low loss with 0.2 dB typical insertion
  • High signal integrity from >38 dB return loss
  • 10 Gbps multimode performance over 30 m
  • Durable 3.0 mm PVC jacket for handling
  • Wide operating range from -20 °C to +60 °C

Enfain OM3 Duplex Patch Cable

This 30 metre multimode fibre patch cable uses OM3 10-gigabit core glass terminated with LC and ST ceramic ferrules. It is built for installers connecting switches, servers or patch panels in data-centre or enterprise racks where 850 nm transmission is required. The aqua jacket identifies the OM3 rating at a glance.

Capacity and headroom for 10G links

The cable supports 1, 10 and 40 gigabit Ethernet over multimode distances with typical insertion loss of .2 dB and maximum of .3 dB. Return loss exceeds 38 dB, preserving signal integrity on short-reach uplinks. It is not suited for single-mode runs or wavelengths beyond 850 nm where a different core would be needed.

Build integration with 3.0 mm jacket

The 3.0 mm PVC jacket meets a 330 mm minimum bend radius and survives 1000 mating cycles across an operating range of -20 °C to +60 °C. Duplex LC-ST ends plug directly into mixed transceivers without adapters, freeing rack space otherwise used by hybrid couplers. Installers needing armoured or plenum-rated sheathing should select a different cable type.

Přednosti

  • Low loss with 0.2 dB typical insertion
  • High signal integrity from >38 dB return loss
  • 10 Gbps multimode performance over 30 m
  • Durable 3.0 mm PVC jacket for handling
  • Wide operating range from -20 °C to +60 °C

Specifikace

Pro tento produkt zatím nejsou zveřejněny žádné specifikace.

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Will the 3.0 mm jacket fit alongside my older patch cords in the same tray?

The cable uses a 3.0 mm PVC jacket, which is a common diameter for multimode patch cords and will sit in standard cable management trays with similar-sized leads.

How can I verify the link is performing to the stated 0.2 dB typical insertion loss after installation?

Use a light source and power meter at 850 nm to measure end-to-end loss; a reading at or below 0.3 dB maximum confirms the connectors and fibre are within spec.

Does the 30 m length include both LC and ST connectors already terminated, or do I need to buy connectors separately?

The patch cord arrives as a finished duplex assembly with LC connectors on one end and ST connectors on the other, so no additional terminations are required.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.