SPARTAN 1-to-9 SATA HDD/SSD Duplicator H09HSHEB
- Hard Drive Duplicat…
- 1 to 9
Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.
HUADISK
1TB M.2 2280 drive delivers up to 7200 MBps read and 6400 MBps write without a heatsink for tight laptop slots
The HUADISK HYV1TBX4(GR) is a 1TB M.2 2280 internal solid state drive built for consumer desktops, laptops and PS5 consoles. It uses a PCI-Express 4.0 x4 interface with NVMe 1.4 protocol and 3D TLC NAND. Sequential reads reach up to 7200 MBps and writes up to 6400 MBps, while random performance hits 720,000 IOPS read and 800,000 IOPS write. No heatsink is attached, keeping the module slim for tight clearances.
Idle power draw is 0.66W and active consumption peaks at 8.18W, so heat output stays modest during everyday workloads. The drive is rated for an operating range of 0°C to 70°C and 5% to 95% humidity, with no moving parts to generate noise. MTBF is specified at 1,000,000 hours and endurance at 600TB written, indicating a design focused on quiet, cool reliability.
Under prolonged heavy I/O the controller can maintain high throughput until thermal limits are approached, at which point firmware throttles performance to stay within the 70°C ceiling. Because the module ships without a heatsink, sustained write runs in poorly ventilated chassis will hit that limit sooner than on drives with integrated cooling. The 600TB TBW rating and 1,000,000 hour MTBF reflect the NAND and controller durability when thermals are managed.
| Brand | HUADISK |
|---|---|
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2280 |
| Capacity | 1TB |
| Interface | PCI-Express 4.0 x4 |
| Protocol | NVMe 1.4 |
| Max Sequential Read | Up to 7200 MBps |
| Max Sequential Write | Up to 6400 MBps |
| 4KB Random Read | Up to 720,000 IOPS |
| 4KB Random Write | Up to 800,000 IOPS |
| Terabytes Written (TBW) | 600TB |
| MTBF | 1,000,000 hours |
| HeatSink | without HeatSink |
| Power Consumption (Idle) | 0.66W |
| Power Consumption (Active) | 8.18W |
| Operating Temperature | 0°C ~ +70°C |
| Storage Temperature | -20°C ~ +75°C |
| Operating Humidity | 5-95% |
| Height | 80.0mm |
| Width | 22.0mm |
| Depth | 2.10mm |
| Weight | 30g |
| Přepravní hmotnost | 0.05 kg |
| Rozměry balení | 102 × 64 × 15 mm |
Insert the drive at an angle into the PCIe 4.0 x4 M.2 slot, press it flat, and secure it with the motherboard screw; the step often missed is tightening that screw, which keeps the NVMe 1.4 SSD from lifting and losing contact.
No routine maintenance is required; the 3D TLC NAND is rated for 600TB TBW and 1,000,000 hours MTBF, so replacement is only needed if the drive exceeds its write endurance or fails after the three-year warranty period.
The controller will throttle speeds once the drive temperature approaches the 70°C operating ceiling, because the model ships without a heatsink and active power draw reaches 8.18W under load.
Také v této kategorii
Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.
Měna, ve které platíte, a měna, ve které se zobrazují ceny.
Odesláno z vaší peněženky u pokladny
Pouze pro zobrazení — katalog je veden v dolarech
Žádná měna neodpovídá.
Vyberte jazyk, ve kterém s vámi bude web komunikovat.
Žádný jazyk neodpovídá.
Poprvé tady?
Už účet máte?
Neexistuje žádná automatická obnova hesla: tento obchod neposílá žádné e-maily, takže neexistuje jednorázový odkaz, o který by bylo možné požádat. Nechte adresu uvedenou u účtu, vyřídíme ji ručně.
Žádost zaznamenána
Do vaší schránky nic nedorazí — tento obchod neposílá žádné e-maily. Někdo se o to postará ručně.
Vzpomněli jste si?