SPARTAN 1-to-9 SATA HDD/SSD Duplicator H09HSHEB
- Hard Drive Duplicat…
- 1 to 9
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
HUADISK
1TB M.2 2280 drive delivers up to 7200 MBps read and 6400 MBps write without a heatsink for tight laptop slots
The HUADISK HYV1TBX4(GR) is a 1TB M.2 2280 internal solid state drive built for consumer desktops, laptops and PS5 consoles. It uses a PCI-Express 4.0 x4 interface with NVMe 1.4 protocol and 3D TLC NAND. Sequential reads reach up to 7200 MBps and writes up to 6400 MBps, while random performance hits 720,000 IOPS read and 800,000 IOPS write. No heatsink is attached, keeping the module slim for tight clearances.
Idle power draw is 0.66W and active consumption peaks at 8.18W, so heat output stays modest during everyday workloads. The drive is rated for an operating range of 0°C to 70°C and 5% to 95% humidity, with no moving parts to generate noise. MTBF is specified at 1,000,000 hours and endurance at 600TB written, indicating a design focused on quiet, cool reliability.
Under prolonged heavy I/O the controller can maintain high throughput until thermal limits are approached, at which point firmware throttles performance to stay within the 70°C ceiling. Because the module ships without a heatsink, sustained write runs in poorly ventilated chassis will hit that limit sooner than on drives with integrated cooling. The 600TB TBW rating and 1,000,000 hour MTBF reflect the NAND and controller durability when thermals are managed.
| Brand | HUADISK |
|---|---|
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2280 |
| Capacity | 1TB |
| Interface | PCI-Express 4.0 x4 |
| Protocol | NVMe 1.4 |
| Max Sequential Read | Up to 7200 MBps |
| Max Sequential Write | Up to 6400 MBps |
| 4KB Random Read | Up to 720,000 IOPS |
| 4KB Random Write | Up to 800,000 IOPS |
| Terabytes Written (TBW) | 600TB |
| MTBF | 1,000,000 hours |
| HeatSink | without HeatSink |
| Power Consumption (Idle) | 0.66W |
| Power Consumption (Active) | 8.18W |
| Operating Temperature | 0°C ~ +70°C |
| Storage Temperature | -20°C ~ +75°C |
| Operating Humidity | 5-95% |
| Height | 80.0mm |
| Width | 22.0mm |
| Depth | 2.10mm |
| Weight | 30g |
| وزن الشحنة | 0.05 kg |
| أبعاد الطرد | 102 × 64 × 15 mm |
Insert the drive at an angle into the PCIe 4.0 x4 M.2 slot, press it flat, and secure it with the motherboard screw; the step often missed is tightening that screw, which keeps the NVMe 1.4 SSD from lifting and losing contact.
No routine maintenance is required; the 3D TLC NAND is rated for 600TB TBW and 1,000,000 hours MTBF, so replacement is only needed if the drive exceeds its write endurance or fails after the three-year warranty period.
The controller will throttle speeds once the drive temperature approaches the 70°C operating ceiling, because the model ships without a heatsink and active power draw reaches 8.18W under load.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟