Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green circuit board SODIMM module with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 8GB DDR4 3200 SODIMM POSIFLEX JK-2732 memory upgrade

SKU CH-P7P5-4JMWT

8GB DDR4 3200 SODIMM upgrade for POSIFLEX JK-2732 kiosks, CL22 1.20V unbuffered non-ECC

  • Capacity8GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 8GB DDR4 3200 SODIMM boosts POSIFLEX JK-2732 kiosk responsiveness
  • CL22 1.20V unbuffered design keeps power draw low
  • 2Rx8 260-pin layout fits the Cachet Series slot exactly
  • Major OEM Samsung Micron Hynix chips deliver tested stability
  • Non-ECC module installs in minutes with no configuration needed

System-specific DDR4 SODIMM for POSIFLEX JK-2732

This 8 GB DDR4 3200 module is built for the POSIFLEX JK-2732 Cachet Series kiosk. It arrives as a single 260-pin unbuffered SODIMM rated at 1.20 V with CL22 latency. The stick uses major OEM chips from Samsung, Micron or Hynix and carries no heat spreader. It is a new, non-ECC upgrade designed for direct replacement in the target terminal.

Suits technicians servicing the JK-2732 platform

The part matches the exact voltage, pin count and form factor required by the kiosk motherboard. It will not fit full-size DIMM slots, nor will it work in systems that demand ECC or registered memory. Buyers who need higher capacity per slot or lower latency timings should look at a different specification. This module addresses the JK-2732 socket only.

2Rx8 rank configuration decides fit

The dual-rank 2Rx8 organisation is the critical parameter the kiosk memory controller expects. A single-rank alternative would change the electrical loading and may prevent the terminal from posting. Verify the service manual calls for 2Rx8 before ordering.

Přednosti

  • 8GB DDR4 3200 SODIMM boosts POSIFLEX JK-2732 kiosk responsiveness
  • CL22 1.20V unbuffered design keeps power draw low
  • 2Rx8 260-pin layout fits the Cachet Series slot exactly
  • Major OEM Samsung Micron Hynix chips deliver tested stability
  • Non-ECC module installs in minutes with no configuration needed

Specifikace

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR4 3200MHZ Non-ECC Unbuffered SODIMM
Part NumberMS25600-828K1
Capacity8GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemPOSIFLEX POS
CAS LatencyCL22
Heat SpreaderNo
Type260-Pin DDR4 SODIMM
Rank2Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content8GB (1X8GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 260-PIN Non-ECC Unbuffered SODIMM

Otázky k tomuto produktu

Should I pick the single 8 GB DDR4 3200 SODIMM or a dual-channel kit for my POSIFLEX JK-2732?

The module is sold as one 8 GB stick (1X8GB). If the kiosk has two slots, adding a second identical module will enable dual-channel bandwidth.

What does the 3200 MT/s rating actually deliver inside the JK-2732 kiosk?

The memory runs at DDR4 3200 (PC4-25600) with CL22 latency at 1.20 V, giving the maximum throughput the platform's memory controller supports.

Is the 260-pin SODIMM interface the limiting factor for speed or capacity?

The 260-pin DDR4 SODIMM form factor carries the 3200 MT/s signal; the 8 GB capacity is set by the 2Rx8 organisation on this module.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.