Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Black fanless 120W DC-DC power board with external 12V adapter and sleeved cables

Silverstone

Silverstone AD120-DC 120W Fanless Power Supply

SKU CH-EK20-RH89N MPN AD120-DC

Fanless 120 W DC-DC kit with 12 V adapter, 24-pin, 8-pin EPS, three SATA and one peripheral connector

  • ColorBlack
  • Maximum Power120 W
  • FansFanless
  • Output10A
  • Connectors1 x 24 pin ATX / 1 x 4 pin Peripheral / 1 x 8 pin (4+4) EPS
  • Cable Spec1 x 24-Pin motherboard connector (200mm) 1 x 8 / 4-Pin EPS /
  • Silent operation with fanless 120 W design
  • Compact DC board fits 160 mm wide spaces
  • External 12 V 10 A adapter keeps heat outside case
  • Full ATX connector set includes EPS and three SATA
  • Black sleeved cables simplify clean cable routing

Compact Fanless Power Kit

The Silverstone AD120-DC delivers 120 W through a fanless DC-DC board paired with a 12 V 10 A AC-DC adapter. It targets builders of compact systems such as the Milo 10 chassis who need silent operation and a minimal footprint. The black-wire loom includes a 24-pin ATX connector, an 8-pin EPS connector, three SATA connectors and one 4-pin peripheral connector.

Upgrade From Flex ATX Units

This kit replaces bulkier flex-ATX or low-profile internal supplies where space and noise are primary constraints. The jump is worthwhile when the total system draw stays within the 120 W limit and the chassis can accommodate the external adapter brick. Builds requiring higher wattage or additional PCIe power connectors cannot use this solution.

Limits of 12 V DC Input

The DC-DC board accepts a single 12 V input rated at 10 A, capping combined output at 120 W across all rails. Cable lengths are fixed at 200 mm for the 24-pin and peripheral leads, 250 mm for the EPS lead, and 300 mm plus two 100 mm branches for the three SATA connectors. The board measures 160 mm by 45 mm by 25 mm, while the adapter measures 168 mm by 71 mm by 37.5 mm.

Přednosti

  • Silent operation with fanless 120 W design
  • Compact DC board fits 160 mm wide spaces
  • External 12 V 10 A adapter keeps heat outside case
  • Full ATX connector set includes EPS and three SATA
  • Black sleeved cables simplify clean cable routing

Specifikace

BrandSilverStone
ModelAD120-DC
ColorBlack
Maximum Power120 W
FansFanless
Output10A
Connectors1 x 24 pin ATX / 1 x 4 pin Peripheral / 1 x 8 pin (4+4) EPS (CPU) / 3 x SATA
Cable Spec1 x 24-Pin motherboard connector (200mm)
1 x 8 / 4-Pin EPS / ATX 12V connector (250mm)
3 x SATA connector (300mm /100mm / 100mm)
1 x 4-Pin Peripheral connector (200mm)
DimensionsDC board dimension: 160mm (W) x 25mm (H) x 45mm (D)
Dimension: 168mm (W) x 71mm (H) x 37.5mm (D)
Přepravní hmotnost1.36 kg
Rozměry balení178 × 76 × 51 mm

Otázky k tomuto produktu

What clearance does the 160 mm wide DC board need inside the case?

The DC board measures 160 mm wide by 45 mm deep by 25 mm high, so allow at least that footprint plus cable bend radius behind the motherboard tray.

Which connector must be seated first to avoid bending the 24-pin cable?

Route the 200 mm 24-pin ATX cable to the motherboard before plugging the 250 mm 4+4-pin EPS and 300 mm SATA leads, otherwise the stiff 24-pin harness can kink.

When should the external 120 W 12 V/10 A AC-DC adapter be replaced?

Replace the adapter if output voltage drifts below 12 V under load or if the unit becomes audibly noisy, as the fanless DC board relies entirely on clean adapter power.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.