Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Black standalone USB duplicator with LCD screen and 31 slots

Systor

Systor SYS-USBD-31 USB Duplicator 1 to 31 targets 33MB/s

SKU CH-FX0V-VYF4M

Standalone USB duplicator copies up to 31 flash drives at 33 MB/s with synchronous and asynchronous modes

  • TypeUSB Flash Drive Duplicator
  • Target1 to 31
  • Buffer Memory256 MB
  • Supported MediaUSB 1.1, USB 2.0, & USB 3.0
  • Data Transfer Rate33MB/s
  • Language SupportEnglish, Japanese, Spanish, Portuguese

Target Size 1 to 31

Zobrazit dalších 7 konfigurací

Přeškrtnuté varianty existují, ale zde nejsou skladem.

DATA TRANSFER RATE USB 2.0/2.1 - 2GB/min [33MB/sec]

  • Copies 31 USB drives simultaneously at 33 MB/s
  • Asynchronous mode lets each channel load and copy independently
  • Standalone operation with LCD and four-key control needs no PC
  • Bit-for-bit hardware compare plus DoD-compliant erase verifies and sanitises data
  • Supports USB 1.1, 2.0 and 3.0 drives with FAT16/32, NTFS and Linux file systems

Standalone 31-target USB duplicator

The Systor SYS-USBD-31 copies up to 31 USB flash drives simultaneously without a host computer. It supports USB 1.1, 2.0 and 3.0 media through a SATA connector and 256 MB of buffer memory. Synchronous and asynchronous modes let each channel load, unload and copy independently. The unit runs on 115/230 V, 50/60 Hz power with a 300 W supply.

Sustained duplication throughput

Real-world copy speed reaches 33 MB/s, which translates to roughly 2 GB per minute across all active ports. Asynchronous operation keeps every channel moving even when drives are swapped mid-job, so total job time scales with the slowest individual drive rather than the batch size. Bit-for-bit hardware comparison verifies each copy after the transfer finishes.

Thermals, noise and power draw

The 300 W internal supply handles peak load while the standalone chassis runs quietly in typical office environments. No external cooling or host-system airflow is required. Power consumption stays within the rated 115/230 V input range during continuous multi-drive duplication cycles.

Přednosti

  • Copies 31 USB drives simultaneously at 33 MB/s
  • Asynchronous mode lets each channel load and copy independently
  • Standalone operation with LCD and four-key control needs no PC
  • Bit-for-bit hardware compare plus DoD-compliant erase verifies and sanitises data
  • Supports USB 1.1, 2.0 and 3.0 drives with FAT16/32, NTFS and Linux file systems

Specifikace

TypeUSB Flash Drive Duplicator
Target1 to 31
Buffer Memory256 MB
Supported MediaUSB 1.1, USB 2.0, & USB 3.0
Data Transfer Rate33MB/s
Language SupportEnglish, Japanese, Spanish, Portuguese
DisplayLCD Screen
Operating TypeStandalone
ConnectorSATA
Panel ColorBlack
Load TypeSlot
Key FeaturesSynchronous or Asynchronous mode
FeaturesQuick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats
Power Supply115/230 V, 50/60 Hz, 300 W

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

How much power does the 300 W supply draw when all 31 targets are copying at 33 MB/s?

The unit uses a 300 W, 115/230 V, 50/60 Hz power supply; actual draw depends on how many of the 31 ports are active and the drives attached.

What drives or cables must I already have to start duplicating with this unit?

You need USB 1.1, 2.0 or 3.0 flash drives to fill the 31 target slots; no host computer, software or extra cables are required for standalone operation.

Will older USB 1.1 flash drives still copy correctly alongside newer USB 3.0 drives in the same batch?

Yes — the duplicator supports USB 1.1, 2.0 and 3.0 media simultaneously, copying each at its own maximum speed in asynchronous mode.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.