Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Black standalone USB duplicator with LCD screen and 31 slots

Systor

Systor SYS-USBD-31 USB Duplicator 1 to 31 targets 33MB/s

SKU CH-FX0V-VYF4M

Standalone USB duplicator copies up to 31 flash drives at 33 MB/s with synchronous and asynchronous modes

  • TypeUSB Flash Drive Duplicator
  • Target1 to 31
  • Buffer Memory256 MB
  • Supported MediaUSB 1.1, USB 2.0, & USB 3.0
  • Data Transfer Rate33MB/s
  • Language SupportEnglish, Japanese, Spanish, Portuguese

Target Size 1 to 31

Näytä 7 muuta kokoonpanoa

Yliviivatut versiot ovat olemassa, mutta niitä ei ole varastossa täällä.

DATA TRANSFER RATE USB 2.0/2.1 - 2GB/min [33MB/sec]

  • Copies 31 USB drives simultaneously at 33 MB/s
  • Asynchronous mode lets each channel load and copy independently
  • Standalone operation with LCD and four-key control needs no PC
  • Bit-for-bit hardware compare plus DoD-compliant erase verifies and sanitises data
  • Supports USB 1.1, 2.0 and 3.0 drives with FAT16/32, NTFS and Linux file systems

Standalone 31-target USB duplicator

The Systor SYS-USBD-31 copies up to 31 USB flash drives simultaneously without a host computer. It supports USB 1.1, 2.0 and 3.0 media through a SATA connector and 256 MB of buffer memory. Synchronous and asynchronous modes let each channel load, unload and copy independently. The unit runs on 115/230 V, 50/60 Hz power with a 300 W supply.

Sustained duplication throughput

Real-world copy speed reaches 33 MB/s, which translates to roughly 2 GB per minute across all active ports. Asynchronous operation keeps every channel moving even when drives are swapped mid-job, so total job time scales with the slowest individual drive rather than the batch size. Bit-for-bit hardware comparison verifies each copy after the transfer finishes.

Thermals, noise and power draw

The 300 W internal supply handles peak load while the standalone chassis runs quietly in typical office environments. No external cooling or host-system airflow is required. Power consumption stays within the rated 115/230 V input range during continuous multi-drive duplication cycles.

Kohokohdat

  • Copies 31 USB drives simultaneously at 33 MB/s
  • Asynchronous mode lets each channel load and copy independently
  • Standalone operation with LCD and four-key control needs no PC
  • Bit-for-bit hardware compare plus DoD-compliant erase verifies and sanitises data
  • Supports USB 1.1, 2.0 and 3.0 drives with FAT16/32, NTFS and Linux file systems

Tekniset tiedot

TypeUSB Flash Drive Duplicator
Target1 to 31
Buffer Memory256 MB
Supported MediaUSB 1.1, USB 2.0, & USB 3.0
Data Transfer Rate33MB/s
Language SupportEnglish, Japanese, Spanish, Portuguese
DisplayLCD Screen
Operating TypeStandalone
ConnectorSATA
Panel ColorBlack
Load TypeSlot
Key FeaturesSynchronous or Asynchronous mode
FeaturesQuick Copy: FAT16/32, NTFS, Linux(EXT2/EXT3/EXT4) Whole Media Copy: All Formats
Power Supply115/230 V, 50/60 Hz, 300 W

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

How much power does the 300 W supply draw when all 31 targets are copying at 33 MB/s?

The unit uses a 300 W, 115/230 V, 50/60 Hz power supply; actual draw depends on how many of the 31 ports are active and the drives attached.

What drives or cables must I already have to start duplicating with this unit?

You need USB 1.1, 2.0 or 3.0 flash drives to fill the 31 target slots; no host computer, software or extra cables are required for standalone operation.

Will older USB 1.1 flash drives still copy correctly alongside newer USB 3.0 drives in the same batch?

Yes — the duplicator supports USB 1.1, 2.0 and 3.0 media simultaneously, copying each at its own maximum speed in asynchronous mode.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.