Jungle Leopard Prism6 MAX 120mm Reverse Blade ARGB Case Fan 3-Pack Black

Reverse Blade ARGB Case Fan 3-Pack

The Jungle Leopard Prism6 MAX 120mm reverse blade fan comes in a three-pack for builders who want coordinated intake or exhaust with a unified lighting theme. Each unit uses a hydraulic bearing and nine balanced blades to move air through radiators or mesh panels. The black frame and 5V 3-pin ARGB connector suit modern motherboard ecosystems. Buyers without a 5V 3-pin header will need a separate controller to synchronise the lighting.

PWM Speed Range and Noise Ceiling

The fan spins between 800 and 1850 RPM with a 10 percent tolerance, delivering 58.36 CFM at 2.07 mmH2O static pressure. At maximum speed the noise level reaches 29 dBA, which is audible in a quiet room but low enough for most desk-side builds. The 4-pin PWM header allows the motherboard to scale speed automatically with temperature curves. Builders who need silent operation below 20 dBA at load should look elsewhere.

5V 3-Pin ARGB Header Requirement

Synchronised lighting only works when the motherboard provides a 5V 3-pin addressable RGB header; a standard 12V 4-pin RGB header cannot drive the LEDs. The fan also includes a small 4-pin power connector for the motor. If your board lacks the 5V 3-pin header, you must add an external ARGB controller to enable colour effects. This single compatibility check decides whether the kit works out of the box.