NEMIX RAM 1TB DDR5 5600 ECC RDIMM 16x64GB CL46 1.1V 2Rx4 288-pin Supermicro H13DSG-OM

1TB DDR5-5600 ECC RDIMM kit for Supermicro H13DSG-OM

This 1TB kit contains sixteen 64GB DDR5 RDIMMs rated at 5600 MT/s with CL46 latency and 1.10V operation. Each module uses a 2Rx4 registered ECC design on a 288-pin form factor built with major OEM DRAM. It is engineered as an exact-match upgrade for the Supermicro H13DSG-OM motherboard where full population and registered signalling are required.

Registered ECC architecture for stable full-load

The registered buffer reduces electrical load on the memory controller so all sixteen slots can run at the rated 5600 speed without down-clocking. On-die ECC detects and corrects single-bit errors in real time, preventing silent data corruption and unplanned reboots during sustained workloads. Modules operate at the standard 1.10V DDR5 voltage and ship without heat spreaders, relying on server chassis airflow for cooling.

Replaces partial or slower memory sets

Install this kit when the board is running fewer than sixteen DIMMs, when installed modules are slower than 5600 MT/s, or when non-ECC UDIMMs are present and registered ECC is required. The upgrade is worth it only if the system manual confirms 1TB maximum capacity and the correct population sequence for sixteen 2Rx4 modules. Buyers who need a different capacity, a UDIMM form factor, or compatibility with another motherboard should not use this kit.