BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 US$
0.00278214BTC
En stock
A-Tech
A-Tech 4GB DDR3 1333MHz PC3-10600 204-Pin SODIMM CL9 1.5V Laptop Memory
A 4 GB DDR3 1333 MHz SODIMM module with CL9 timing and 1.5 V operation for compatible laptop upgrades
- Capacity4GB
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3 1333 (PC3 10600)
- CAS LatencyCL9
- Voltage1.50V
- ECCNo
- Boosts multitasking with 4GB DDR3 1333MHz CL9
- Fits Dell systems using part numbers A2885458 A3418018 A3520618 A3558401 A3583836 A3583839 A3944758 A4100451 A4105743 A4427377 A4501461
- Standard 204-pin SODIMM installs in laptop DDR3 slots
- Runs at 1.5V DDR3 voltage for broad compatibility
- Tested modules deliver reliable performance for everyday workloads
4GB DDR3 SODIMM for laptop upgrades
This 4GB DDR3 module runs at 1333MHz with CL9 latency and 1.5V operation. It uses a 204-pin SO-DIMM form factor and unbuffered, non-ECC architecture. The stick is built with major-brand chips and targets AMD and Intel laptop platforms needing a straightforward memory increase.
204-pin SO-DIMM build and compatibility
The module follows the standard 204-pin DDR3 SO-DIMM layout, so it fits the memory slots of compatible Dell laptops referenced by part numbers such as A3583836, A5039671, A4427377 and others listed. Unbuffered design means it installs directly without registered-buffer circuitry. Verification of the system's supported memory specification remains essential before installation.
Standard voltage thermals and power draw
Operating at the DDR3 standard 1.5V keeps power draw and heat output within normal limits for this memory class. The CL9 timing at 1333MHz delivers typical latency for everyday multitasking and application loads. No active cooling is required; the module relies on passive heat dissipation inside the laptop chassis.
Puntos fuertes
- Boosts multitasking with 4GB DDR3 1333MHz CL9
- Fits Dell systems using part numbers A2885458 A3418018 A3520618 A3558401 A3583836 A3583839 A3944758 A4100451 A4105743 A4427377 A4501461
- Standard 204-pin SODIMM installs in laptop DDR3 slots
- Runs at 1.5V DDR3 voltage for broad compatibility
- Tested modules deliver reliable performance for everyday workloads
Especificaciones
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1333 (PC3 10600) |
| CAS Latency | CL9 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Features | Major Brand Chips |
| Recommend Use | AMD & Intel Compatible |
Preguntas sobre este artículo
What bandwidth does the DDR3 1333 PC3-10600 interface provide?
The DDR3 1333 PC3-10600 interface runs at 1333 MHz with a peak transfer rate of 10600 MB/s.
Will this 204-pin SODIMM fit my laptop's memory slot?
This module uses the standard 204-pin DDR3 SO-DIMM form factor used by most DDR3 laptops and all-in-one systems.
How do I install the module and what common mistake should I avoid?
Power off the laptop, remove the battery if possible, open the memory compartment, align the notch on the module with the slot key, insert at an angle, then press down firmly until the side clips click; the common mistake is not pressing hard enough to engage both clips.
También en este pasillo
Los clientes también compararon
Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.
BFKK
BFKK 2U Micro ATX Rackmount 2×5.25" 4×3.5" Side 80mm Fan
- Rackmount
216,99 US$
0.00280802BTC
En stock
