Computer Memory Solutions CM5126412800DIMMHDR 4GB DDR3 1600MHz CL11 2Rx8 1.5V Non-ECC DIMM memory upgrade

Targeted 4 GB DDR3 upgrade

This 4 GB DDR3-1600 module is built for the HP EliteDesk 705 G1 Series SFF. It fits the 240-pin DIMM slots and runs at 1.5 V without ECC or buffering. The kit contains a single stick for straightforward capacity increases.

4 GB capacity with 32 GB system ceiling

The EliteDesk 705 G1 SFF supports up to 32 GB across four slots, so this module adds headroom for everyday multitasking. The chipset limits the memory bus to 1333 MHz, so the stick will run at that speed instead of its rated 1600 MHz. A 64-bit operating system is required to address more than 4 GB in total.

Low-voltage unbuffered operation

At 1.5 V and CL11 the module draws modest power and generates little heat, aided by the absence of a heat spreader. Unbuffered, non-ECC design keeps latency low for typical office workloads. Passive cooling in the small-form-factor chassis is sufficient for normal use.