DELL
DELL 0VPTJ 1.8TB 10K SAS 6Gbps 2.5" internal hard drive
A 1.8 TB enterprise SAS drive spinning at 10 000 RPM in a 2.5 inch form factor
- InterfaceSAS 6Gb/s
- Capacity1.8TB
- RPM10000 RPM
- UsageFor Enterprise Storage
- Form Factor2.5"
- 8 TB capacity supports large enterprise datasets
- 10 000 RPM spindle delivers fast transactional throughput
- SAS 6 Gb/s interface provides reliable dual-port connectivity
- 5 inch form factor fits dense server chassis
- New condition ensures full manufacturer specification compliance
Enterprise 1.8TB SAS Drive
This 2.5 inch internal hard drive delivers 1.8TB of storage over a SAS 6Gb/s interface. It spins at 10000 RPM and is built for enterprise storage workloads. The drive is supplied in new condition.
Suited For High-IOPS Arrays
It fits servers and storage arrays that require a 10K SAS spindle for transactional databases or virtualisation hosts. Buyers needing larger capacity per spindle or solid-state latency should evaluate other media. Systems limited to SATA-only backplanes cannot use this drive.
SAS 6Gb/s Interface Decides Fit
The controller or backplane must provide a SAS 6Gb/s connection to operate this unit. A SATA-only port will not recognise the drive. Verify the host interface before purchase.
Puntos fuertes
- 8 TB capacity supports large enterprise datasets
- 10 000 RPM spindle delivers fast transactional throughput
- SAS 6 Gb/s interface provides reliable dual-port connectivity
- 5 inch form factor fits dense server chassis
- New condition ensures full manufacturer specification compliance
Especificaciones
| Interface | SAS 6Gb/s |
|---|---|
| Capacity | 1.8TB |
| RPM | 10000 RPM |
| Usage | For Enterprise Storage |
| Form Factor | 2.5" |
Preguntas sobre este artículo
How much heat and noise does the 10000 RPM SAS drive add when it runs continuously in a server?
The 1.8TB 10K RPM SAS 6Gb/s drive is rated for enterprise storage workloads and uses the standard 2.5-inch form factor; its power draw and acoustics follow Dell's specifications for this model.
What controller and cables are required to connect this 2.5-inch SAS drive to an existing system?
A SAS host bus adapter or RAID controller with internal Mini-SAS ports and matching cables is needed; the drive plugs into a standard 2.5-inch SAS backplane or drive bay.
Will this 1.8TB 10K SAS drive work in a chassis that currently holds 2.5-inch SATA drives?
The drive fits the same 2.5-inch bays, but the backplane and controller must support SAS 6Gb/s signalling; SATA-only backplanes will not operate this drive.
También en este pasillo
Los clientes también compararon
Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.
