DELL
DELL 400-AIFT 400 GB 2.5" SATA 6.0Gb/s internal solid state drive
A 400 GB 2.5-inch SATA solid-state drive with hot-plug support for internal storage upgrades
- PackagingBare Drive
- InterfaceSATA 6.0Gb/s
- Capacity400GB
- Form Factor2.5"
- 400 GB capacity stores large data volumes
- SATA 6.0 Gb/s interface enables fast transfer speeds
- 5 inch form factor fits standard drive bays
- Hot-pluggable design allows drive swaps without shutdown
- Mix-use MLC flash balances read and write performance
Dell 400 GB SATA Solid State Drive
This Dell 400-AIFT solid state drive provides 400 GB of internal storage for compatible Dell systems. It uses a SATA 6.0Gb/s interface and a 2.5 inch form factor. The drive supports hot-plug operation so it can be swapped without powering down the host.
Suited for Dell storage upgrades and hot-swap bays
The mix-use MLC design handles both read and write workloads in Dell servers or workstations that accept 2.5 inch SATA drives. It is not intended for systems that only support 3.5 inch bays or for users who require a different physical connector.
SATA 6.0Gb/s interface determines compatibility
The drive communicates over the SATA/600 standard, so the host must provide a matching SATA port and 2.5 inch mounting. Without that interface the drive cannot be installed or used.
Puntos fuertes
- 400 GB capacity stores large data volumes
- SATA 6.0 Gb/s interface enables fast transfer speeds
- 5 inch form factor fits standard drive bays
- Hot-pluggable design allows drive swaps without shutdown
- Mix-use MLC flash balances read and write performance
Especificaciones
| Brand | Dell |
|---|---|
| Model | 400-AIFT |
| Packaging | Bare Drive |
| Interface | SATA 6.0Gb/s |
| Capacity | 400GB |
| Form Factor | 2.5" |
Preguntas sobre este artículo
How much heat and power does the 400 GB SATA 6.0Gb/s drive generate during continuous all-day operation?
As a solid-state drive with no moving parts, it runs silently and produces minimal heat compared to mechanical disks, drawing low power typical of 2.5" SATA SSDs under sustained mixed-use workloads.
What cables or host connectors must I already have to install this 2.5" SATA 6.0Gb/s drive?
You need a standard SATA data cable and a SATA power connector from your power supply; the drive uses the SATA/600 interface and fits any 2.5" drive bay or caddy.
Will this hot-pluggable 400 GB SATA SSD work alongside an older mechanical hard drive in the same system?
Yes, it connects via the same SATA interface as legacy drives, so the BIOS and operating system will recognise both devices simultaneously without configuration changes.
También en este pasillo
Los clientes también compararon
Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.
