Aceptamos criptomonedas — así, las criptos que usted tiene pueden comprar hardware real.Pague en cripto y gástela en hardware real. Envío asegurado gratis a nivel mundial a partir de $399. Cajas neutras, sin marca, enviadas desde Alemania.Envío asegurado gratis a partir de $399. Su cotización queda bloqueada 30 minutos en cuanto se abre el pago.Cotización bloqueada 30 minutos. Todos los artículos vienen sellados, con el número de serie verificado y cubiertos por una garantía de 24 meses.Sellado, con 24 meses de garantía.

Artículos guardados Iniciar sesión
Eight green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM 128GB (8x16GB) DDR5-5600 ECC RDIMM CL46 1.1V Supermicro H13SSW memory upgrade

SKU CH-731J-SFVPY

A 128GB DDR5-5600 ECC RDIMM kit of eight 16GB modules at CL46 and 1.1V, verified for Supermicro H13SSW servers

  • Capacity128GB (8 x 16GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 128GB 8X16GB

Ver 24 configuraciones más
  • 128 GB total capacity from eight 16 GB modules
  • DDR5-5600 speed with CL46 latency for rated performance
  • Registered ECC architecture prevents silent data corruption
  • 1 V operation matches server memory controller requirements
  • 288-pin RDIMM form factor verified for Supermicro H13SSW

Exact-Match DDR5 Kit for Supermicro H13SSW

This 128 GB kit contains eight 16 GB DDR5-5600 registered ECC RDIMMs built to the precise rank, voltage and timing the motherboard expects. Each module runs at 1.1 V with CL46 latency and a 1Rx8 organisation so the memory controller recognises the full capacity at rated speed.

Capacity and Registered Headroom

Eight single-rank modules fill every slot while the registered architecture buffers address and command signals, letting the memory controller drive a fully populated system without signal degradation. ECC corrects single-bit errors on the fly, preventing silent data corruption that would otherwise crash production workloads.

DDR5 RDIMM Interface Constraints

The 288-pin RDIMM form factor is required; UDIMM or SODIMM modules will not fit or function in this platform. Population rules and maximum supported capacities are defined by the motherboard manual, so the installer must verify the approved DIMM order before seating the kit.

Puntos fuertes

  • 128 GB total capacity from eight 16 GB modules
  • DDR5-5600 speed with CL46 latency for rated performance
  • Registered ECC architecture prevents silent data corruption
  • 1 V operation matches server memory controller requirements
  • 288-pin RDIMM form factor verified for Supermicro H13SSW

Especificaciones

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-618K8
Capacity128GB (8 x 16GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content128GB 8X16GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC RDIMM KIT

Otras versiones de este modelo

5 más en esta gama

Misma familia, con memoria, disipador o frecuencia diferentes — compare antes de decidirse.

Preguntas sobre este artículo

Will this DDR5-5600 ECC RDIMM kit run at full speed alongside existing DDR5-4800 modules in my Supermicro H13SSW?

Mixing different DDR5 speeds forces the memory controller to run all modules at the lowest common speed. The board will downclock this 5600 MT/s kit to match the slower modules.

How can I verify the kit is recognised as 128 GB at DDR5-5600 with ECC active after installation?

Enter the BIOS or UEFI and check the memory information screen. It should show 128 GB total, 5600 MT/s operating speed, and ECC status reported as enabled or active.

Does the MR44800-618K8 box include a heat spreader or any installation tools, or must I buy them separately?

The modules ship without a heat spreader. The kit contains only the eight 16 GB RDIMMs. No tools are included; a standard Phillips screwdriver is all that is needed for installation.

También en este pasillo

Los clientes también compararon

Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.