BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 US$
0.0027634BTC
En stock
NEMIX RAM
NEMIX RAM 64GB (4x16GB) DDR5 5600 CL46 ECC UDIMM Lenovo ST250 V3
64 GB DDR5 ECC UDIMM kit (4 × 16 GB) at 5600 MT/s CL46 for Lenovo ThinkSystem ST250 V3
- Capacity64GB (4 x 16GB)
- SpeedDDR5 5600 (PC5 44800)
- ECCYes
- Buffered/RegisteredUnbuffered
- ChipsetMajor OEM Samsung, Micron, Hynix
- Voltage1.10V
- 64 GB total capacity across four 16 GB modules
- DDR5 5600 speed with CL46 latency for responsive server workloads
- ECC protection detects and corrects single-bit errors
- 1 V operation reduces power draw in the ST250 V3
- 288-pin UDIMM form factor fits the tower server memory slots
Lenovo ThinkSystem ST250 V3 compatible kit
This 64 GB kit contains four 16 GB DDR5 ECC unbuffered UDIMMs validated for the Lenovo ThinkSystem ST250 V3 tower server. The modules run at 5600 MT/s with a CAS latency of 46 at 1.1 V. The 288-pin layout matches the server's memory slots directly.
Suits admins upgrading ST250 V3 memory
Buyers who need error-correcting memory for this specific Lenovo platform can install the kit without additional configuration. The unbuffered design fits the ST250 V3's memory architecture. Systems that require registered or load-reduced DIMMs cannot use these modules. Builds that demand a heat spreader on every stick should look elsewhere.
1Rx8 rank organisation
Each module uses a single-rank 1Rx8 organisation, which the ST250 V3 memory controller expects for optimal population. Mixing ranks or using dual-rank DIMMs may reduce the number of usable slots or limit the maximum capacity the server can address.
Puntos fuertes
- 64 GB total capacity across four 16 GB modules
- DDR5 5600 speed with CL46 latency for responsive server workloads
- ECC protection detects and corrects single-bit errors
- 1 V operation reduces power draw in the ST250 V3
- 288-pin UDIMM form factor fits the tower server memory slots
Especificaciones
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM Original Series Memory |
| Model | DDR5 ECC Unbuffered UDIMM Memory |
| Part Number | ME44800-618K4 |
| Capacity | 64GB (4 x 16GB) |
| Speed | DDR5 5600 (PC5 44800) |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.10V |
| Compatible System | Lenovo |
| CAS Latency | CL46 |
| Heat Spreader | No |
| Type | 288-Pin DDR5 ECC UDIMM |
| Rank | 1Rx8 |
| Features | DDR5 ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 64GB (4 x 16GB) DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN ECC UDIMM KIT |
Preguntas sobre este artículo
Does my Lenovo ThinkSystem ST250 V3 server need any specific BIOS setting to recognise the 5600MHz DDR5 ECC UDIMM kit?
The server will auto-negotiate the 5600MHz speed and CL46 timings at 1.10V on first boot; no manual configuration is required beyond seating all four 288-pin modules in the approved slots.
Will the four 16GB 1Rx8 DDR5 ECC UDIMMs work if I leave older DDR5 modules in the remaining slots?
Mixing ranks or speeds forces the memory controller to run at the lowest common denominator; for stable ECC operation Lenovo recommends populating every channel with identical 1Rx8 5600MHz modules, so remove any dissimilar sticks.
How can I confirm the full 64GB kit is running at 5600MHz with ECC active after installation?
Enter the UEFI setup or run a tool such as dmidecode; you should see four 16GB 1Rx8 DDR5 modules at 5600MT/s, PC5-44800, CL46, 1.10V and ECC enabled.
También en este pasillo
Los clientes también compararon
Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.
BFKK
BFKK 2U Micro ATX Rackmount 2×5.25" 4×3.5" Side 80mm Fan
- Rackmount
216,99 US$
0.00278911BTC
En stock
