NEMIX RAM DDR5 5600 CL46 384GB (4×96GB) ECC RDIMM for Supermicro H13SST-G memory upgrade

Exact-Match DDR5 Kit for Supermicro H13SST-G

This 384 GB kit contains four 96 GB DDR5 5600 RDIMMs built to the precise rank, voltage and timing the server memory controller expects. It is designed for administrators upgrading a Supermicro H13SST-G motherboard with registered ECC memory that will be recognised at full capacity and run at its rated speed. The modules use 2Rx4 organisation and operate at 1.10 V. They are not intended for workstations or desktops that require unbuffered DIMMs or SODIMM form factors.

Registered ECC Architecture and Verified Fitment

Registered buffering offloads the memory controller so every slot runs fully populated at full capacity while ECC corrects single-bit errors on the fly to prevent silent data corruption and unplanned reboots. The 288-pin RDIMM form factor matches the board's physical and electrical requirements and is spec-matched to its memory-population rules. No heat spreaders are included and the kit contains only the four memory modules.

Check Motherboard Manual Before Ordering

Server and motherboard memory support varies by model so consult your system or motherboard manual for supported capacities, approved DIMM population order and installation steps before purchase. Verify that your platform accepts 2Rx4 registered DDR5 RDIMMs at 5600 MT/s and that the BIOS revision in use supports the full 384 GB configuration. Buyers needing a different capacity, rank configuration or unbuffered memory should select an alternative kit.