Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään

NEMIX RAM

NEMIX RAM DDR5 5600 ECC Registered RDIMM 384GB 12x32GB Supermicro H14DST-FL memory upgrade

SKU CH-AATM-H25KN

384 GB DDR5-5600 ECC Registered RDIMM kit with twelve 32 GB modules at CL46, 1.1 V, 2Rx8, 288-pin, validated for Supermicro H14DST-FL

  • Capacity384GB (12 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 384 GB total capacity across 12 matched 32 GB modules
  • DDR5 5600 speed with CL46 latency for rated server performance
  • Registered ECC design corrects single-bit errors and buffers the memory controller
  • 1 V operation at 2Rx8 rank matches Supermicro H14DST-FL requirements
  • 288-pin RDIMM form factor ensures exact physical and electrical fit

384GB DDR5 RDIMM kit for Supermicro H14DST-FL

This kit supplies 384GB across twelve 32GB DDR5 5600 RDIMM modules built to the Supermicro H14DST-FL motherboard's exact requirements. Registered ECC architecture and 2Rx8 organization match the board's memory controller expectations for full-capacity recognition. System integrators and IT teams upgrading compatible Supermicro platforms receive a validated, single-part-number solution.

Sustained-load behaviour with registered ECC

Registered buffering reduces electrical load on the memory controller so all twelve slots remain stable at the rated 5600 MT/s speed under continuous throughput. ECC corrects single-bit errors on the fly preventing silent data corruption during long compute runs. CL46 latency and 1.1V operation maintain efficiency without throttling when the system runs fully populated for extended periods.

Installation notes and common pitfalls

Modules are 288-pin RDIMMs without heat spreaders so they seat directly into the board's DDR5 DIMM slots following the manual's population sequence. The kit will not fit UDIMM or SODIMM sockets and cannot be mixed with unregistered or non-ECC memory. Verify the motherboard's approved DIMM order and maximum supported capacity per slot before installation to avoid a no-post condition.

Kohokohdat

  • 384 GB total capacity across 12 matched 32 GB modules
  • DDR5 5600 speed with CL46 latency for rated server performance
  • Registered ECC design corrects single-bit errors and buffers the memory controller
  • 1 V operation at 2Rx8 rank matches Supermicro H14DST-FL requirements
  • 288-pin RDIMM form factor ensures exact physical and electrical fit

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-328K12
Capacity384GB (12 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content384GB 12X32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 1.1 V DDR5 5600 kit add noticeable heat when all twelve slots are populated on the H14DST-FL?

At 1.1 V the modules run at the standard DDR5 5600 voltage, so thermal load matches the board's rated design for full 12-slot population.

What must the server already have to accept this 12 x 32 GB registered ECC kit?

A Supermicro H14DST-FL motherboard with twelve free 288-pin RDIMM slots and a BIOS that supports 384 GB of DDR5 5600 registered ECC memory.

Can the CL46 2Rx8 RDIMMs share channels with older DDR5 modules already in the system?

Mixing ranks, latencies or voltages is not recommended; the board's memory controller expects identical 2Rx8 CL46 1.1 V modules in every populated slot for stable operation.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.