BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
8GB DDR3L 1600 CL11 1.35V 204-pin SODIMM laptop memory upgrade compatible with NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131
This 8GB DDR3L module runs at 1600 MHz with CL11 latency and 1.35 V operation. It uses a 204-pin SO-DIMM form factor and is unbuffered non-ECC memory. The part is listed as a direct replacement for NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131.
Builders whose hardware requires DDR3L at 1.35 V and a 204-pin slot can use this module. It is not for systems that need registered or ECC memory, nor for platforms that only accept 1.5 V DDR3. Buyers who need a higher capacity per slot or a different pin layout should look elsewhere.
The single specification that decides fit is the 1.35 V operating voltage combined with DDR3L 1600 speed. If the target device specifies 1.5 V DDR3 only, this module will not be compatible. Confirm the system documentation calls for DDR3L 1.35 V before purchase.
| Brand | OWC |
|---|---|
| Part Number | 1S6T32R808GB |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Recommend Use | Laptops, All-in-One Systems, and NAS Systems |
Yes, the module is built to the JEDEC-standard 204-pin DDR3L form factor and matches the NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131.
Align the notch with the slot key, insert at an angle, then press down evenly until both side clips snap into place — forcing one side first often bends the retention arm.
No firmware or battery is involved; the module is a passive JEDEC-compliant DDR3L device, so only a future capacity upgrade would replace it.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?