BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
8GB DDR3L 1600 CL11 1.35V 204-pin SODIMM laptop memory upgrade compatible with NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131
This 8GB DDR3L module runs at 1600 MHz with CL11 latency and 1.35 V operation. It uses a 204-pin SO-DIMM form factor and is unbuffered non-ECC memory. The part is listed as a direct replacement for NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131.
Builders whose hardware requires DDR3L at 1.35 V and a 204-pin slot can use this module. It is not for systems that need registered or ECC memory, nor for platforms that only accept 1.5 V DDR3. Buyers who need a higher capacity per slot or a different pin layout should look elsewhere.
The single specification that decides fit is the 1.35 V operating voltage combined with DDR3L 1600 speed. If the target device specifies 1.5 V DDR3 only, this module will not be compatible. Confirm the system documentation calls for DDR3L 1.35 V before purchase.
| Brand | OWC |
|---|---|
| Part Number | 1S6T32R808GB |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Recommend Use | Laptops, All-in-One Systems, and NAS Systems |
Yes, the module is built to the JEDEC-standard 204-pin DDR3L form factor and matches the NCR part numbers 497-0506041, 497-0514577, 7702-K138 and 7761-K131.
Align the notch with the slot key, insert at an angle, then press down evenly until both side clips snap into place — forcing one side first often bends the retention arm.
No firmware or battery is involved; the module is a passive JEDEC-compliant DDR3L device, so only a future capacity upgrade would replace it.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟