Zyvpee
Zyvpee JF0825B2HSAR 80mm 25mm 24V 0.15A 3-wire case fan
An 80 mm by 25 mm case fan with ball bearing runs on 24 V at 0.15 A using a three-wire connector for inverter cooling
- TypeCase Fan
- Bearing TypeBall
- Power Connector3 Wires
- ColorBeige / Brown
- LEDNon-LED
- Featuresinverter Cooling
- 24 V operation suits industrial and server chassis
- Ball bearing construction extends service life
- 80 mm frame fits standard mounting holes
- 25 mm thickness clears tight clearances
- Three-wire connector enables speed monitoring
Zyvpee 80 mm 24 V Case Fan
This 80 mm case fan runs on 24 V DC and draws 0.15 A through a three-wire connector. It uses a ball bearing and is built in a beige and brown frame. The unit is designed for inverter cooling in server or workstation environments.
Suited for 24 V Server Cooling
Technicians maintaining equipment that provides a 24 V fan header will find this fan a direct fit. Builders whose chassis or controller only supplies lower voltages cannot use this model without additional hardware. The non-LED design keeps the installation visually neutral.
24 V 0.15 A Three-Wire Power Specification
The 24 V, 0.15 A rating and three-wire interface are the critical parameters for compatibility. Verify that your system delivers exactly this voltage and connector type before purchase. Mismatched power will prevent the fan from operating.
Kohokohdat
- 24 V operation suits industrial and server chassis
- Ball bearing construction extends service life
- 80 mm frame fits standard mounting holes
- 25 mm thickness clears tight clearances
- Three-wire connector enables speed monitoring
Tekniset tiedot
| Brand | 3ccooler.com |
|---|---|
| Series | JF0825B2HSAR |
| Model | JF0825B2HSAR |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 3 Wires |
| Color | Beige / Brown |
| LED | Non-LED |
| Features | inverter Cooling |
| Dimensions | 80*25mm |
Kysymyksiä tästä tuotteesta
What voltage and current does the 3-wire connector on the JF0825B2HSAR require?
The fan runs on 24V and draws .15A through its three-wire lead, so the header or supply must provide that exact voltage and current.
Will the 80mm by 25mm frame fit a standard 8025 mounting pattern?
Yes — the housing measures 80 by 25mm, matching the common 8025 screw-hole spacing used on many server and inverter chassis.
How do I connect the three wires correctly, and what mistake should I avoid?
Match the three leads to the corresponding pins on a 24V three-pin header; the common error is reversing the tachometer and ground wires, which stops speed reporting.
Myös tällä osastolla
Asiakkaat vertailivat myös näitä
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 $
0.0000105BTC
Varastossa