Zyvpee
Zyvpee JF0825B2HSAR 80mm 25mm 24V 0.15A 3-wire case fan
An 80 mm by 25 mm case fan with ball bearing runs on 24 V at 0.15 A using a three-wire connector for inverter cooling
- TypeCase Fan
- Bearing TypeBall
- Power Connector3 Wires
- ColorBeige / Brown
- LEDNon-LED
- Featuresinverter Cooling
- 24 V operation suits industrial and server chassis
- Ball bearing construction extends service life
- 80 mm frame fits standard mounting holes
- 25 mm thickness clears tight clearances
- Three-wire connector enables speed monitoring
Zyvpee 80 mm 24 V Case Fan
This 80 mm case fan runs on 24 V DC and draws 0.15 A through a three-wire connector. It uses a ball bearing and is built in a beige and brown frame. The unit is designed for inverter cooling in server or workstation environments.
Suited for 24 V Server Cooling
Technicians maintaining equipment that provides a 24 V fan header will find this fan a direct fit. Builders whose chassis or controller only supplies lower voltages cannot use this model without additional hardware. The non-LED design keeps the installation visually neutral.
24 V 0.15 A Three-Wire Power Specification
The 24 V, 0.15 A rating and three-wire interface are the critical parameters for compatibility. Verify that your system delivers exactly this voltage and connector type before purchase. Mismatched power will prevent the fan from operating.
Najważniejsze cechy
- 24 V operation suits industrial and server chassis
- Ball bearing construction extends service life
- 80 mm frame fits standard mounting holes
- 25 mm thickness clears tight clearances
- Three-wire connector enables speed monitoring
Specyfikacja
| Brand | 3ccooler.com |
|---|---|
| Series | JF0825B2HSAR |
| Model | JF0825B2HSAR |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 3 Wires |
| Color | Beige / Brown |
| LED | Non-LED |
| Features | inverter Cooling |
| Dimensions | 80*25mm |
Pytania dotyczące tego produktu
What voltage and current does the 3-wire connector on the JF0825B2HSAR require?
The fan runs on 24V and draws .15A through its three-wire lead, so the header or supply must provide that exact voltage and current.
Will the 80mm by 25mm frame fit a standard 8025 mounting pattern?
Yes — the housing measures 80 by 25mm, matching the common 8025 screw-hole spacing used on many server and inverter chassis.
How do I connect the three wires correctly, and what mistake should I avoid?
Match the three leads to the corresponding pins on a 24V three-pin header; the common error is reversing the tachometer and ground wires, which stops speed reporting.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 USD
0.00001049BTC
Dostępny