暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Pack of 25 beige through-hole 10K ohm carbon film resistors with thin axial leads

Adafruit

Adafruit Through-Hole Resistors 10K ohm 5% 1/4W 25 pack engineering development tool

SKU CH-WHND-ZVM0Q

A 25-pack of 10K ohm carbon film through-hole resistors rated at 5% tolerance and 300V max voltage

  • TypePrototyping Products
  • 25 resistors per pack for multiple projects
  • 10K ohm carbon film handles 300V max
  • 5% tolerance gives predictable circuit behaviour
  • 1/4W rating suits common low-power designs
  • 4mm leads plug straight into solderless breadboards

Resistor pack for breadboard prototyping

This 25 pack supplies 10K ohm carbon film resistors rated at 1/4 watt and 5 percent tolerance. The .4 millimetre leads plug securely into solderless breadboards, perf-boards or any through-hole project. They suit hobbyists, students and engineers building or repairing circuits. No other values or quantities are included.

Passive components generate no heat or noise

Resistors of this type dissipate up to 1/4 watt during normal operation and remain silent. They draw only the current dictated by the surrounding circuit and require no active cooling. Power handling stays within the stated 300 volt maximum across the element.

25 pieces at a single 10K ohm value

The pack contains exactly twenty-five identical resistors, so every lead pair measures 10K ohm. Projects needing multiple values, surface-mount parts or higher power ratings will need additional components.

特長

  • 25 resistors per pack for multiple projects
  • 10K ohm carbon film handles 300V max
  • 5% tolerance gives predictable circuit behaviour
  • 1/4W rating suits common low-power designs
  • 4mm leads plug straight into solderless breadboards

仕様

TypePrototyping Products

この商品に関する質問

How do I install the 10K ohm carbon film resistors onto a solderless breadboard?

Push the 0.4mm thick axial leads straight into the breadboard holes until the resistor body sits flush; the common mistake is bending the leads beforehand, which makes insertion harder.

What maintenance or replacement will the 25 pack of 10K ohm 1/4W resistors need later?

No scheduled maintenance is required; replace any resistor that exceeds its 1/4W dissipation or 300V limit, or that shows physical damage after prolonged use.

What limit shows up first when the 10K ohm 1/4W carbon film resistors run under sustained load?

The 1/4W power rating is reached before the 300V voltage limit, so sustained current that would dissipate more than 1/4W is the first constraint.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。