暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Orange and black braided PSU cable extension kit with 24-pin, two CPU and three GPU connectors, plus cable combs

myVolts

myVolts 50cm PSU Cable Extension Kit OrangeBlack 2xCPU 3xGPU 24Pin 18AWG

SKU CH-3WP9-TZC7B

A 50cm sleeved PSU cable extension kit with 1x24-pin, 2xCPU and 3xGPU connectors using 18AWG UL 1015 tinned copper wire and cable combs

  • TypeAT
  • Complete PSU extension kit with 2 CPU, 3 GPU and 24-pin cables
  • 18AWG UL 1015 tinned copper wires for heat and humidity resistance
  • High-density braided sleeves with 18 included cable combs for clean routing
  • 50 cm length in OrangeBlack, one of 17 colour options
  • Flexible design trains easily to custom curves without pre-shaping

Build your look

This kit bundles a 24-pin ATX extension, two 4+4-pin CPU extensions and three 6+2-pin GPU extensions in one package. The 500 mm length suits full-tower and mid-tower builds that need extra reach for clean routing. Enthusiasts who want a single colour scheme across every power lead will find the OrangeBlack finish ready to match.

Wire and combs

Each lead uses 18 AWG UL 1015 tinned copper conductors inside a high-density braided sleeve that resists heat and humidity. The sleeve stays flexible enough to train around tight corners without kinking. Fifteen 8-pin combs and three 24-pin combs are included to lock cables into parallel runs for a professional finish.

Signal integrity

The thicker 18 AWG gauge reduces voltage drop across the 50 cm extension compared with thinner alternatives. Tinned copper strands resist oxidation so contact resistance stays low over time. No active components are added, so the kit draws no extra power and adds no audible noise to the system.

特長

  • Complete PSU extension kit with 2 CPU, 3 GPU and 24-pin cables
  • 18AWG UL 1015 tinned copper wires for heat and humidity resistance
  • High-density braided sleeves with 18 included cable combs for clean routing
  • 50 cm length in OrangeBlack, one of 17 colour options
  • Flexible design trains easily to custom curves without pre-shaping

仕様

TypeAT

この商品に関する質問

Does the 24-pin ATX extension follow the standard ATX pin-out and length limit?

The 24-pin extension uses the standard ATX pin-out and adds 50 cm to the existing cable run, staying within typical routing limits for full-tower cases.

What clearance and comb spacing do the 18 AWG sleeved cables need behind the motherboard tray?

The high-density braid on 18 AWG UL 1015 wire adds roughly 3 mm of diameter, so allow at least 20 mm behind the tray and use the supplied 24-pin and 8-pin combs to lock spacing.

How do I install the extensions without kinking the braid at the PSU-side connectors?

Route each extension from the component back to the PSU, seat the factory connectors first, then snap the combs on 2 cm intervals; the step most builders miss is tightening combs before the final bend.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。