暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Black 50mm sleeve-bearing cooling fan with two-wire 12V .14A connector

SunnyStar Co., Ltd

SunnyStar Co., Ltd RDM5015S 50mm 12V .14A Sleeve Bearing Fan

SKU CH-H5ED-D2NAV

A 50 mm sleeve-bearing fan running at 12 V and .14 A for charger or inverter cooling

  • ColorBlack
  • TypeFan only
  • Fan Size50mm
  • Bearing TypeSleeve Bearing
  • Power Connector2 Pin
  • LEDNo
  • 50 mm compact frame fits tight chassis spaces
  • 12 V .14 A draw keeps power use low
  • sleeve bearing runs quietly at modest speeds
  • two-pin connector enables simple plug-in installation
  • suits charger and inverter cooling duties

50 mm 12 V sleeve-bearing fan

This 50 mm cooling fan runs on 12 V and draws .14 A through a two-pin connector. It uses a sleeve bearing and has no LED lighting. The unit is sold as a fan only in black.

Suits tight 50 mm mounts and 12 V DC circuits

Builders who need a larger frame, a three- or four-pin PWM header, ball-bearing longevity or RGB illumination should look elsewhere. The two-wire design also rules out speed reporting or motherboard fan curves.

50 mm frame decides fit

The 50 mm square footprint is the single dimension that determines whether this fan will screw into your charger, inverter or compact cooler. Verify the mounting holes match before ordering.

特長

  • 50 mm compact frame fits tight chassis spaces
  • 12 V .14 A draw keeps power use low
  • sleeve bearing runs quietly at modest speeds
  • two-pin connector enables simple plug-in installation
  • suits charger and inverter cooling duties

仕様

ModelRDM5015S
ColorBlack
TypeFan only
Fan Size50mm
Bearing TypeSleeve Bearing
Power Connector2 Pin
LEDNo

この商品に関する質問

How do I install the 50 mm sleeve-bearing fan with its 2-pin connector?

Align the 50 mm frame with the mounting holes, secure it with four screws, then plug the 2-pin connector into a 12 V header; the step often missed is checking that the red wire goes to the positive pin.

What maintenance will the RDM5015S sleeve bearing need later?

Sleeve bearings cannot be relubricated easily; when noise or vibration appears after extended running, the usual remedy is to replace the entire 5015s fan.

What limit appears first when the 12 V .14 A fan runs continuously?

The sleeve bearing’s lubricant degrades with constant heat, so bearing wear and rising noise typically become the first limiting factor under sustained operation.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。