SunnyStar Co., Ltd
SunnyStar Co., Ltd RDM5015S 50mm 12V .14A Sleeve Bearing Fan
A 50 mm sleeve-bearing fan running at 12 V and .14 A for charger or inverter cooling
- ColorBlack
- TypeFan only
- Fan Size50mm
- Bearing TypeSleeve Bearing
- Power Connector2 Pin
- LEDNo
- 50 mm compact frame fits tight chassis spaces
- 12 V .14 A draw keeps power use low
- sleeve bearing runs quietly at modest speeds
- two-pin connector enables simple plug-in installation
- suits charger and inverter cooling duties
50 mm 12 V sleeve-bearing fan
This 50 mm cooling fan runs on 12 V and draws .14 A through a two-pin connector. It uses a sleeve bearing and has no LED lighting. The unit is sold as a fan only in black.
Suits tight 50 mm mounts and 12 V DC circuits
Builders who need a larger frame, a three- or four-pin PWM header, ball-bearing longevity or RGB illumination should look elsewhere. The two-wire design also rules out speed reporting or motherboard fan curves.
50 mm frame decides fit
The 50 mm square footprint is the single dimension that determines whether this fan will screw into your charger, inverter or compact cooler. Verify the mounting holes match before ordering.
Najważniejsze cechy
- 50 mm compact frame fits tight chassis spaces
- 12 V .14 A draw keeps power use low
- sleeve bearing runs quietly at modest speeds
- two-pin connector enables simple plug-in installation
- suits charger and inverter cooling duties
Specyfikacja
| Model | RDM5015S |
|---|---|
| Color | Black |
| Type | Fan only |
| Fan Size | 50mm |
| Bearing Type | Sleeve Bearing |
| Power Connector | 2 Pin |
| LED | No |
Pytania dotyczące tego produktu
How do I install the 50 mm sleeve-bearing fan with its 2-pin connector?
Align the 50 mm frame with the mounting holes, secure it with four screws, then plug the 2-pin connector into a 12 V header; the step often missed is checking that the red wire goes to the positive pin.
What maintenance will the RDM5015S sleeve bearing need later?
Sleeve bearings cannot be relubricated easily; when noise or vibration appears after extended running, the usual remedy is to replace the entire 5015s fan.
What limit appears first when the 12 V .14 A fan runs continuously?
The sleeve bearing’s lubricant degrades with constant heat, so bearing wear and rising noise typically become the first limiting factor under sustained operation.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
0,82 USD
0.00001041BTC
Dostępny