BUCIER USB 2.0 A Male to 5-Pin Screw Terminal Adapter 2-Pack

Two-pack USB 2.0 screw-terminal adapter

This two-pack provides a USB 2.0 Type-A male plug on one end and a five-pin screw-terminal block on the other. Each unit measures 5 cm by 2.1 cm by 1.2 cm and follows the USB 2.0 wiring standard with shield, power, data-minus, data-plus and ground pins. The solderless design lets installers terminate wires using only a screwdriver and wire stripper.

Makers extending USB cables without soldering

The adapter suits hobbyists and technicians who need to lengthen or repair USB 2.0 cables in custom enclosures, test fixtures or prototype boards. Users requiring a sealed industrial connector, a right-angle form factor or support for USB 3.0 and higher speeds should look at other solutions.

Solderless termination speeds up wiring

The pluggable screw terminals accept AWG 28-16 solid or stranded wire and remove the need for a soldering iron. This reduces assembly time and allows quick rewiring during development or field service. No software or drivers are included because the device is a passive wiring adapter.