HPE Juniper Networking
HPE Juniper Networking EX3400 Fan Module Back-To-Front Airflow
Fan module provides back-to-front cooling for EX3400-24P, EX3400-48P, EX3400-24T and EX3400-48T switches
- Keeps switches cool with back-to-front airflow design
- Reduces noise by running at moderate speed normally
- Automatically increases fan speed when chassis temperature rises
- Compatible with EX3400-24P, EX3400-48P, EX3400-24T, EX3400-48T models
- New factory-sealed module with part number EX3400-FAN-AFI
Fan Module for EX3400 Switches
This Juniper Networks fan module provides back-to-front airflow for the EX3400 series. It pulls cool air into the chassis and exhausts heat from the front panel. The unit suits network administrators deploying EX3400-24P, EX3400-48P, EX3400-24T, or EX3400-48T switches in standard hot-aisle or cold-aisle layouts.
Replacement Cooling Unit
The module replaces a failed or missing fan tray in compatible EX3400 switches to restore proper thermal management. A swap is warranted when the original unit develops bearing noise, reports a fault LED, or cannot spin up under rising internal temperatures. It is not suited for front-to-back airflow racks or non-EX3400 chassis.
Chassis Integration
The fan unit slides into the dedicated slot on supported EX3400 models without tools. Temperature sensors in the chassis govern automatic speed control, ramping rotation only when heat loads demand it. This behaviour keeps acoustic output low during typical operation while freeing rack space otherwise needed for external cooling ductwork.
주요 특징
- Keeps switches cool with back-to-front airflow design
- Reduces noise by running at moderate speed normally
- Automatically increases fan speed when chassis temperature rises
- Compatible with EX3400-24P, EX3400-48P, EX3400-24T, EX3400-48T models
- New factory-sealed module with part number EX3400-FAN-AFI
사양
| Series | EX3400 |
|---|
이 상품에 대한 질문
Does the EX3400-FAN-AFI module fit the EX3400-24T and EX3400-48P switches?
Yes, this fan module is compatible with the EX3400-24T, EX3400-48T, EX3400-24P and EX3400-48P models.
How do I install the fan module so the back-to-front airflow works correctly?
Slide the module into the chassis slot until the latch clicks; the unit pulls cool air from the rear and exhausts it out the front.
When should I replace the EX3400-FAN-AFI unit?
Replace the module if the fans run constantly at high speed, produce unusual noise, or the chassis temperature sensor reports overheating.
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
Mushkin Enhanced 4GB DDR2-800 CL6 SoDIMM Apple 971741A memory upgrade
SK hynix HYMD232M646C6-J 256MB DDR 333MHz PC2700 CL2.5 SODIMM laptop RAM
- 4GB (2 x 2GB)



