Thermal Grizzly Minus Pad Pro 2-pack 120x20x2.0mm thermal pad

Thermal Pad for SSDs and GPUs

This Thermal Grizzly Minus Pad Pro pack contains two grey thermal interface pads sized 120 x 20 mm with a 2.0 mm thickness. They are designed to transfer heat from SSDs, GPU coolers, graphics card water blocks, voltage regulators and memory modules. The electrically non-conductive material prevents short circuits while filling gaps between surfaces. Builders upgrading laptop or desktop storage and graphics cooling will find the dimensions suit many M.2 slots and VRM arrays.

Who benefits and who should look elsewhere

The pads suit enthusiasts who need reliable gap-filling on flat components such as M.2 drives or GPU memory chips where a 2.0 mm thickness matches the stock pad. They are less suited for buyers who need a thinner or thicker pad for tighter or looser clearances, or for anyone wanting a paste instead of a pre-cut pad. The two-piece pack also limits coverage for large heatsinks or multiple devices in one session.

Fitting into a cooling build

Each pad can be trimmed with scissors to match the exact footprint of an SSD controller, VRM row or GPU die. Because the material is non-conductive, no insulating tape is required around exposed PCB traces. The 120 mm length allows a single strip to span several memory modules on a graphics card, freeing the builder from cutting many small squares. No curing time is needed, so the system can be reassembled and tested immediately.