NEMIX RAM 64GB DDR4 3200 4Rx4 1.2V 288-PIN ECC LRDIMM server RAM
- DDR4 3200 (PC4 2560…
- 22
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A-Tech
A 16 GB DDR4-2133 ECC registered DIMM with CL15 timing for compatible Dell servers
This 16 GB DDR4 2133 MHz registered DIMM is built for Dell servers and workstations that require ECC memory. It replaces Dell part numbers such as 01R8CR, 0237FC, 370-ABUG and A7945660. The module uses a 288-pin form factor and major-brand chips to deliver reliable capacity for multi-tasking and virtualised workloads. Systems needing non-ECC or unbuffered memory cannot use this module.
The module runs at the DDR4 standard voltage of 1.20 V with a CL15 latency rating. Registered buffering reduces electrical load on the memory controller, helping to keep power draw steady during normal multi-user operation. ECC circuitry corrects single-bit errors without adding audible noise, since the module has no moving parts. Thermal output remains consistent with typical DDR4 RDIMM behaviour in adequately ventilated chassis.
Under continuous workloads such as database serving or virtualisation hosting, the registered design maintains signal integrity across all 16 GB. ECC protection operates continuously to prevent data corruption during long compute sessions. The 2Rx4 organisation supports dense memory configurations without exceeding the electrical limits of the platform. Buyers needing higher frequencies or lower latencies should verify platform support before ordering.
| Brand | A-Tech |
|---|---|
| Capacity | 16GB |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
Align the notch on the module with the key in the slot, press firmly until both side clips click shut, then verify in BIOS that the 16GB module is detected at 2133MHz with ECC active.
No routine maintenance is required; if a correctable error count rises or the module fails POST, replace the individual 16GB stick — ECC lets the server run until you schedule the swap.
The DDR4 2133MT/s bandwidth ceiling is reached before thermal or voltage limits, so throughput plateaus at the rated PC4-17000 speed under continuous load.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?