A-Tech 512GB (4x128GB) DDR4 3200 ECC LRDIMM 4Rx4 Server RAM
- 512GB (4 x 128GB)
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A-Tech
Eight 128 GB DDR4 2933 ECC registered DIMMs deliver 1 TB of quad-rank 3DS server memory at 1.2 V and CL21 latency
Capacity 1TB (8 x 128GB)
This 1 TB kit contains eight 128 GB DDR4 2933 MHz ECC registered DIMMs built for servers and workstations. Each module uses a 288-pin form factor and quad-rank 3DS/TSV organisation to maximise density per channel. The kit is intended for administrators expanding memory capacity in compatible DDR4 server platforms only.
Operating at the standard DDR4 voltage of 1.20 V, the modules run within typical server thermal envelopes without additional cooling requirements. Registered buffering reduces electrical load on the memory controller, helping maintain signal integrity across all eight slots. No active cooling or acoustic profile is specified for this memory kit.
The 1 TB total capacity delivered through eight quad-rank 3DS modules determines whether the target system can address this density per channel. Compatibility depends on the platform's qualified vendor list and maximum supported rank count per channel. Desktop and laptop systems cannot use these registered ECC DIMMs.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR4 Server Memory RAM |
| Model | A-Tech 128GB 2S2Rx4 PC4-2933Y-R |
| Capacity | 1TB (8 x 128GB) |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2S2Rx4 (4Rx4 3DS/TSV) |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
Power down the server, open the chassis, align each module's notch with the slot key, press firmly until both ejector clips lock, then verify in BIOS that all eight 128 GB modules are detected at 2933 MHz; the step often missed is checking the system manual for the correct channel population order.
No routine maintenance is required; keep air intakes clean so the 1.2 V modules stay cool, and replace any stick only if memtest or the server's ECC logger reports uncorrectable errors on that specific 128 GB module.
The memory controller's maximum supported rank count per channel is reached before bandwidth or thermal limits, so the system must support 4Rx4 3DS/TSV organisation to use all eight modules at 2933 MHz.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?