We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with black memory chips and gold contacts, 240-pin DDR3 DIMM module

A-Tech

A-Tech 4GB DDR3 1333MHz PC3-10600 240-Pin 1Rx8 HP 497158 Desktop RAM

SKU CH-976N-TQHD0

A 4 GB DDR3 1333 MHz desktop DIMM with 240 pins, CL9 latency and 1.5 V operation for HP 497158 systems

  • Capacity4GB
  • SpeedDDR3 1333 (PC3 10600)
  • Tested Frequency1333
  • CAS LatencyCL9
  • Voltage1.50V
  • ECCNo
  • 4GB capacity adds headroom for everyday multitasking
  • 1333MHz DDR3 speed matches PC3-10600 system bus
  • 240-pin DIMM fits standard desktop memory slots
  • 50V standard voltage keeps power draw predictable
  • Tested with major-brand chips for reliable operation

4GB DDR3 1333MHz Desktop Module

This 4GB DDR3 1333MHz module uses the 240-pin DIMM form factor and runs at the standard 1.5V. It is built as a non-ECC unbuffered stick with CL9 timing for everyday desktop workloads. The single 1Rx8 rank keeps the design simple for mainstream boards.

Thermals Noise and Power Draw

At the standard 1.50V the module draws only modest power and produces little heat during typical office tasks. Passive cooling from normal case airflow is sufficient because the low voltage and single rank limit thermal output. No active fan is required and acoustic impact is negligible.

Tested Compatibility and Support

Every stick is tested to meet the PC3-10600 specification before it ships, reducing the chance of boot issues. The part is listed as a direct replacement for the HP 497158-W01 reference, simplifying verification for that platform. US-based technical support is available for configuration questions.

Highlights

  • 4GB capacity adds headroom for everyday multitasking
  • 1333MHz DDR3 speed matches PC3-10600 system bus
  • 240-pin DIMM fits standard desktop memory slots
  • 50V standard voltage keeps power draw predictable
  • Tested with major-brand chips for reliable operation

Specifications

BrandA-Tech
Capacity4GB
SpeedDDR3 1333 (PC3 10600)
Tested Frequency1333
CAS LatencyCL9
Voltage1.50V
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor Brand Chips
FeaturesMajor Brand Chipset
Recommend UseAMD & Intel Compatible

Questions about this item

How do I install the 240-pin DDR3 DIMM, and which step do people often get wrong?

Align the notch on the module with the slot key, press down firmly until both side clips click into place. The step people miss is pushing hard enough to engage both clips; a single click means the module is not fully seated.

What maintenance or replacement will this 4GB DDR3 module need later?

No routine maintenance is required. If errors appear, run a memory diagnostic; the module either passes or it must be replaced as a single 4GB unit.

What limit shows up first under sustained use with this CL9 1.50V DDR3 module?

The 1333 MHz speed and CL9 latency are the fixed performance ceiling; sustained workloads cannot exceed the rated frequency or tighten the timings.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.