NEMIX RAM 64GB DDR4 3200 4Rx4 1.2V 288-PIN ECC LRDIMM server RAM
- DDR4 3200 (PC4 2560…
- 22
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Brute Networks
An 8 GB DDR4 SODIMM running at 2400 MHz with CL15 latency and 1.2 V operation
This 8 GB DDR4-2400 module uses the Z9H56AA part reference and runs at 1.2 V with CL15 latency. It is built from major-brand DRAM chips and is 100 % compatible with systems that accept this specification. The unregistered, non-ECC design suits standard laptop and compact workstation slots.
Operating at the standard 1.20 V DDR4 voltage keeps heat output low inside thin chassis. The single-rank 1Rx8 organisation reduces electrical load on the memory controller, helping the system stay quiet during everyday multitasking. No active cooling is required for this module.
Swapping out a 4 GB stick or a lower-speed DDR4 module instantly adds capacity and bandwidth for heavier browser tabs, office suites and light creative workloads. The jump is worth it when the current memory limit forces frequent swapping to storage. Systems already at the maximum supported capacity or requiring registered ECC DIMMs cannot use this module.
| Brand | HP |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
Align the notch with the slot key, press firmly until both side clips click, then verify the module sits flush — the clips must lock audibly or the contact pads will not seat.
No routine maintenance is required; if errors appear, reseat the module and run a memory test — replacement is only needed if the module itself fails.
The CL15 latency at 2400 MHz sets the throughput ceiling; sustained heavy workloads will hit that bandwidth limit before thermal or voltage constraints arise.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?