EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Computer Memory Solutions
An 8 GB DDR4 2400 MHz SO-DIMM module built for HP G2 and G3 Desktop Mini PC 260 systems
This 8 GB DDR4 SO-DIMM is built for the HP G2 and G3 Desktop Mini PC 260 models. It delivers 2400 MHz speed with CL17 timing at the standard 1.2 V. The unbuffered, non-ECC module uses a 2Rx8 rank layout on major-brand chips. It installs directly into the 260-pin slot without any configuration changes.
Operating at 1.2 V keeps power consumption low inside the compact Mini chassis. No heat spreader is fitted, so the module relies on the system's existing airflow. The low voltage and unbuffered design produce minimal extra heat during typical workloads. Fan noise and thermals remain unchanged from the factory configuration.
The single stick occupies one of the two available SO-DIMM slots, leaving the second free for a future upgrade. Maximum supported memory for these platforms is 32 GB, so adding another 8 GB or larger module is possible. Compatibility is validated for the listed HP part numbers including 1MV60UT and W4A54EA. No additional cables, brackets or BIOS updates are required.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM1024642400SO |
| Capacity | 8GB |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Timing | 17-17-17 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | HP/Compaq G2 Desktop Mini PC 260, G3 Desktop Mini PC 260 |
| Package Content | 1Memory Ram Stick |
Power off and unplug the mini PC, remove the chassis cover, align the notch on the 260-pin SO-DIMM with the slot key, press firmly until the side clips click, then replace the cover before powering on.
No routine maintenance is required; the unbuffered non-ECC DDR4 stick has no moving parts, so replacement is only necessary if a manufacturing defect appears or if the system later needs more than the 32 GB maximum across its two slots.
The 8 GB capacity ceiling is reached before thermal or bandwidth limits; once the operating system exhausts the single 8 GB rank, it must swap to storage, which degrades responsiveness far earlier than the 1.2 V DDR4-2400 interface saturates.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?