EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Computer Memory Solutions
A 4 GB DDR3L 1600 MHz SODIMM module rated at CL11 and 1.35 V, built for the Dell Latitude 15 3000 3550
This 4GB DDR3L SODIMM is built specifically for the Dell Latitude 15 3000 3550. It delivers a direct-fit memory increase for users whose workflow is constrained by the factory configuration. The module uses major-brand components and is tested for guaranteed compatibility with the identified laptop model.
Operating at 1.35V, the DDR3L standard reduces power draw and heat output compared to standard DDR3 modules running at higher voltages. CL11 timing at 1600MHz provides stable responsiveness for everyday multitasking without increasing thermal load on the compact laptop chassis. The unbuffered, non-ECC design keeps latency low for typical client workloads.
The Latitude 15 3000 3550 supports a maximum of 16GB across two sockets. This single 4GB stick leaves one slot open for a future matching module to reach 8GB in dual-channel mode. Buyers needing the full 16GB limit immediately should populate both slots with 8GB modules instead of adding to an existing smaller stick.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM5126412800SOSRL |
| Capacity | 4GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Timing | 11-11-11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell Latitude 15 3000 (3550) |
| Package Content | 1 Memory RAM Stick |
Power off, unplug, and remove the battery. Open the memory door, align the notch on the 204-pin stick with the slot key, insert at an angle, then press down firmly until both side clips click. The step often missed is not pressing hard enough to fully seat the module.
The module has no heat spreader and no moving parts, so no routine maintenance is required. If a memory error appears later, the stick itself would be replaced under the manufacturer's lifetime exchange warranty.
The CL11 latency and 1600 MHz speed set the throughput ceiling. Under continuous load the memory controller will hit its maximum bandwidth before the module overheats, since there is no heat spreader to trap heat.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?