We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Purple and white plastic momentary switch cable with red and green LEDs, 20 inch length

Corn Electronics

Corn Electronics 20" Power Reset Switch Cable with Red Green LEDs motherboard accessory

SKU CH-7W25-5A305

A 20-inch momentary power and reset switch cable with red and green LED indicators for ATX front-panel headers

  • 20-inch cable reaches front-panel headers easily
  • Momentary push-button controls power and reset functions
  • Red and green LEDs show power and drive activity
  • Five-piece kit includes two switches and three LEDs
  • Each wire is clearly labeled for simple installation

Front-panel replacement kit

This accessory kit replaces the power and reset switches plus three status LEDs on a standard ATX front panel. It is intended for PC builders or repair technicians who need to refresh worn or damaged case controls. The momentary push buttons and labelled connectors simplify installation on compatible motherboard headers. No other components are included in the package.

Limited to ATX front-panel headers

The cable connects only to the standard two-pin Power SW, Reset SW, Power LED+, Power LED- and HDD LED headers found on ATX motherboards. It cannot be used with proprietary front-panel connectors or non-ATX form factors. The 50 cm length restricts routing to cases where the motherboard sits within that distance of the front bezel. Longer runs would require a different cable assembly.

Dual-colour LED indication

Two LEDs provide red and green illumination for power and drive-activity status. Builders who require additional colours, more than two indicators or a different voltage interface will need a separate solution. The momentary switch action is fixed and does not support latching or alternate switching modes.

Highlights

  • 20-inch cable reaches front-panel headers easily
  • Momentary push-button controls power and reset functions
  • Red and green LEDs show power and drive activity
  • Five-piece kit includes two switches and three LEDs
  • Each wire is clearly labeled for simple installation

Specifications

No published specifications for this item yet.

Questions about this item

Should I choose the 20-inch or 50 cm cable length?

They are the same length; 20 inches equals 50 cm, so either figure describes the identical cable.

What does the 20-inch cable length mean once installed in my case?

It gives you roughly 50 cm of wire between the front-panel header and the button, enough reach for most mid-tower and full-tower chassis.

Which motherboard header standard does the 2-pin connector follow?

The 2-pin momentary switch plugs into the standard ATX front-panel Power SW or Reset SW header found on virtually all desktop boards.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.