We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 3.5 inch SATA hard drive with circuit board visible

DELL

DELL WD1003FBYX-18Y7BO 1TB 7.2K 6G 3.5" SATA internal hard drive

SKU CH-T39D-JPM1W MPN WD1003FBYX-18Y7BO

A 1 TB SATA desktop hard drive spinning at 7200 rpm in a 3.5 inch form factor for Dell PowerEdge R710 and R720 servers

  • 1 TB capacity for bulk storage
  • 7200 RPM spindle for responsive data access
  • SATA III interface for broad desktop compatibility
  • 5 inch form factor fits standard drive bays
  • Designed for Dell PowerEdge R710 R720 R720XD systems

Dell 1 TB SATA hard drive for servers

This 1 TB Dell hard drive uses a 3.5 inch form factor and a SATA interface with 7200 RPM rotation speed. It is built for internal desktop or server storage bays. The drive carries the WD1003FBYX-18Y7BO model number and is supplied new.

Suits admins expanding R710, R720 or R720XD arrays

This drive fits Dell PowerEdge R710, R720 and R720XD systems that accept 3.5 inch SATA drives. Builders needing a different interface, a smaller form factor, or a higher capacity should look at something else.

7200 RPM spindle speed

The 7200 RPM rotation speed determines the drive’s sustained throughput and access latency. Match this speed to the workload requirements of the target server before purchase.

Highlights

  • 1 TB capacity for bulk storage
  • 7200 RPM spindle for responsive data access
  • SATA III interface for broad desktop compatibility
  • 5 inch form factor fits standard drive bays
  • Designed for Dell PowerEdge R710 R720 R720XD systems

Specifications

No published specifications for this item yet.

Questions about this item

How much noise and heat does the 7200RPM 3.5" SATA drive produce during continuous operation?

The 7200RPM spindle speed and 3.5" form factor mean the drive will generate typical mechanical noise and heat for a desktop-class SATA drive under sustained load; ensure your chassis has adequate airflow.

What existing hardware is required to install this 1TB SATA III 3.5" drive?

You need a free 3.5" drive bay, a SATA data cable, a SATA power connector from your power supply, and a motherboard or controller with an available SATA III port.

Will this 6G SATA drive work reliably in an older system that only supports 3G SATA?

Yes, the SATA III interface is backward compatible with 3G SATA ports; the drive will operate at the slower 3G speed without any configuration changes.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.