Intel DC S3610 SSDSC2BX016T401 1.6TB 2.5" SATA enterprise SSD
- 2.5"
- 1.6TB
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Eluktronics
M.2 2280 NVMe drive with 4000 GB capacity and sequential speeds up to 4700 MB/s read and 3400 MB/s write
The Eluktronics MANIX 4000GB-G4SS is a 4TB internal solid-state drive built in the M.2 2280 form factor. It connects through a PCIe 4.0 x4 interface using the NVMe protocol. The drive uses 3D QLC NAND flash and is assembled double-sided with a height of 2.23mm.
This drive suits users who need a large, single volume for games, media libraries or project files and who have a motherboard with an M.2 slot wired for PCIe 4.0 x4. Systems limited to PCIe 3.0 will see sequential speeds capped at roughly 3400 MB/s. The module ships without a heatsink, so the host board must provide adequate airflow or a dedicated cooler.
Under continuous write loads the QLC architecture will settle to lower throughput once its SLC cache fills, and the controller may throttle if the NAND temperature rises without a heatsink. The rated MTBF of 1500000 hours reflects long-term reliability under typical consumer write patterns rather than enterprise-grade endurance. Thermal management becomes the main factor that keeps performance consistent during extended transfers.
| Brand | Eluktronics |
|---|---|
| Series | MANIX |
| Model | MANIX4000GB-G4SS |
| Device Type | Internal Solid State Drive (SSD) |
| Used For | Consumer |
| Form Factor | M.2 2280 |
| Capacity | 4TB |
| Memory Components | QLC |
| Interface | PCI-Express 4.0 x4 |
| Max Sequential Read | Up to 4700 MBps |
| Max Sequential Write | Up to 3400 MBps |
| MTBF | 1,500,000 hours |
| HeatSink | without HeatSink |
| Height | 2.23mm |
| Width | 22mm |
| Depth | 80mm |
Yes. The drive uses the M.2 2280 form factor measuring 22mm wide, 80mm long and 2.23mm high, which matches the standard slot dimensions used in most modern laptops and desktops.
The drive ships without a heatsink. The supplier strongly recommends adding one when running at PCIe 4.0 speeds to prevent thermal throttling and keep performance consistent.
On a PCIe 3.0 x4 interface the drive is limited to a maximum of 3400 MB/s read and write due to the bus bandwidth ceiling.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?